Projecta EVAPT1T2 User manual
WARNING
• For charging EV Vehicles only.
• Ifdamageddonotattempttouse.Itmustbereplacedorrepairedbyaqualiedperson.
• This adaptor is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
• Children should be supervised to ensure that they do not play with the appliance.
CARE INSTRUCTIONS
• Try and keep clean, avoid mud and harsh chemicals.
• Clean cable and connector housing with mild detergent and water.
• Apply lubricated contact cleaner to the power terminals regularly.
EV ADAPTOR
TYPE 1 TO TYPE 2 ADAPTOR
For charging a Type 2 vehicle at a Type 1 charging station.
P/No. EVAPT1T2
INSTRUCTIONS FOR USE
1. Connect the adaptor to the charging station.
2. Plug your charging inlet lead to the adaptor.
3. Connect the outlet of the charging lead to the car.
4. To stop charging. Follow the reverse procedure.
SPECIFICATIONS
WARRANTY STATEMENT
Brown&WatsonInternationalPtyLtd(“BWI”)of1500FerntreeGullyRoad,Knoxeld,Vic.,telephone(03)9730
6000,fax(03)97306050,warrantsthatallproductsdescribedinitscurrentcataloguewillundernormaluseand
service be free of failures in material and workmanship for a period of one (1) year from the date of the original
purchase by the customer as marked on the invoice. This warranty does not cover ordinary wear and tear, abuse,
alteration of products or damage caused by the purchaser.
To make a warranty claim the consumer must deliver the product at their cost to the original place of purchase
or to any other place which may be nominated by either BWI or the retailer from where the product was bought
in order that the warranty assessment may be performed. The consumer must also deliver the original invoice
evidencing the date and place of purchase together with an explanation in writing as to the nature of the claim.
In the event that the claim is determined to be for a minor failure of the product then BWI reserves the right to
repair or replace it at its discretion. In the event that a major failure is determined the consumer will be entitled to
a replacement or a refund as well as compensation for any other reasonably foreseeable loss or damage.
This warranty is in addition to any other rights or remedies that the consumer may have under State or Federal
legislation.
IMPORTANT NOTE
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled
to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or
damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality
and the failure does not amount to a major failure.
Distributed by
AUSTRALIA
Brown & Watson International Pty. Ltd.
KnoxeldVictoria3180
Phone:(03)97306000
Fax:(03)97306050
NationalTollFree:1800113443
PART NO. EVAPT1T2
RATED CURRENT 32A Max
RATED VOLTAGE 250V AC
INGRESS PROTECTION IP23
VOLTAGE WITHSTAND 2000V AC 5S
FLAME-RETARDANT UL94V-0
WORKING TEMPERATURE -30°C ~ +50°C
NEW ZEALAND OFFICE
Grifths Equipment Ltd.
19BellAvenue,
Mount Wellington,
Auckland 1060, New Zealand
Phone:(09)5254575
IS533
Issue 1 3.3.23
T1 INLET
Socket Side
T2 OUTLET
Vehicle Side
Table of contents
Other Projecta Receiver manuals
