ProLine Range Hoods PLZI GL2.30-48 Assembly instructions

Island Mount PLZI Island
Style Range Hoods
PLZI GL2.30-48
PLZI GL1.30-36
PLZI KE2.30-48
PLZI GL7.36
PLZI GL6.36
PLZI GL9.30-36
PLZI GL5.30-36
PLZI GL2.30-48B
PLZI GL5.30-36B
PLZI KE2.30-48B

2

3

Please unpack your range hood
when it is delivered and inspect
to ensure all parts are included.
1. Main Hood with all lights
and button banks pre-
installed.
2. Adjustable Stainless
Chimney Cover
3. Flexible duct (not
pictured)
4. Packet of screws and
anchors
.5.Island style mounting
bracket
6. Backdraft Damper
4

Installation:
5

6
Five Easy Steps to Installation
Step one: Locate the center
above the stove where the hood
is to be installed. Ensure that the
bracket will be secured to solid
wood backing. Install the duct
work in the center of the bracket.
Secure the upper end of the
bracket to the ceiling as show in
fig.1.
fig.1
Step two: Attach back draft
damper to top of hood to prevent
outside air from entering. fig.2
Step three: Attach the lower
portion of the chimney to the
motor housing with the screws
provided. fig.3
fig.2
fig.3

7
Step four: Attach the duct to the top
of the back draft damper. Place the
chimney sections over the lower
bracket section and on top of the
main unit. Pull the plug to the top of
the chimney sections. Attach lower
bracket to upper bracket at desired
height using screws provided. fig.4
fig.4
fig.5
fig.6
Step 5: Make your electrical and
ducting connections. Use 6” rigid
duct wherever possible. Try and
minimize the use of elbows. More
elbows and longer runs create higher
static pressure. The hood comes
with a grounded three prong plug
that can either be direct wired or
plugged into a 20 amp. circuit. Next
slide the inner portion of the chimney
up around the upper bracket and
secure using the screws provided.

8

Range Hood Operations
9

Filter Installations
It is recommended to direct vent the hood whenever possible.
If your situation does not allow for a direct vent install carbon
filters are available to recirculate the air through your hood.
10

Release
The baffle filter can also be
opened for easy cleaning. To
open unscrew the cylindrical
handle and separate the layers
to clean.
Baffle Filter
The baffle filter is equipped with a spring
loaded handle. To remove from the hood
pull back toward the wall and down.
Release
Aluminum Filter
To remove the filter pull the spring loaded
handle back toward the wall and down
11

12

Electrical Diagram
Circuit Box Cover
Button Bank
Light Transformer
Ground
Motor
Puck Light
Puck Light
Plug
Capacitor
Circuit Board
13
Separate Diagram

Motor Diagram
14

15

ProLine Range Hoods, LLC 1750 South 500 West, Suite 200 Salt Lake City, UTAH 84115 USA
801.973.0863 Toll Free 877.901.5530
www.prolinerangehoods.com