Promolife Hydrogen Water Tumbler User manual

Hydrogen Water Tumbler
GL-102-PW
smell emerges, you can soak the bottle
in hot water (not more than 140F) for
five minutes. Do NOT pour boiling water
into the tumbler.
Servicing the Unit
Warranty service should be completed
by a factory authorized distributor only.
Contact Promolife via our support page
at www.promolife.com/support if you
need product assistance.
Specifications
Power USB 5V / 2.5 A
Maximum Output ≤ 10W
Maximum Volume 450ml
Water Quality Purified Water
Water Temperature 2-60C / 35-140F
Size 74x350mm
Net Weight 1.34lb
Hydrogen
Concentration 2500-4000ppb
ORP -350mv ~
600mv
Bottle Materials Boroscilicate
Glass
WWW.PROMOLIFE.COM
Visit Us on Social Media
www.facebook.com/promolifeinc
www.twitter.com/promolifeinc
www.youtube.com/user/promolife
www.instagram.com/promolifeinc/

Thank you for your purchase!
The Hydrogen Water Tumbler uses
SPE technology to turn any purified
water source in ultra pure hydrogen-
rich water with no ozone or chlorine.
Need help? Visit www.promolife.com/support
Important Information
What kind of water can I use? For best
results, use high quality drinking water.
This can be distilled, purified or reverse
osmosis water. Do not use other liquids,
particularly soda, as the pressure created
could break the bottle.
Before First Use: Before using the unit
for the first time, or after a long period
between uses, the Dupont membrane
may need to be rehydrated. To do this,
place hot water into the tumbler and turn
the unit on and off ten times. Do not use
water over 140F.
Storing Hydrogen Water: Hydrogen water
can be stored in the refrigerator as long
as the tumbler is fully closed. If storing in
an unsealed container, the hydrogen will
fade quickly.
Do Not Soak: Do not put the entire tumbler
into water. Immersing the bottom of
the tumbler can damage the electrical
components and void all warranties.
Things to Avoid: Keep the tumbler away
from freezing temperatures. Keep the unit
out of direct sunlight. Avoid using strong
chemicals or organic solvents when
cleaning. Use hot water (no higher than
140F) to clean.
Parts Diagram
Pressure Cap
450ml Glass Bottle
Electrolysis Plate
Hydrogen Generator
Switch
Using the Battery Charger
Before using for the first time, or after a
long period between uses, connect the
tumbler to the battery charger. The red
light will flash while charging and will
stop when charging is complete.
Do not place the charger in direct
sunlight or use it with other products.
Using the Tumbler
1. Make sure the bottle is clean, then
pour in purified drinking water. Screw
the cover on tightly.
2. To produce hydrogen for nine
minutes, press the power button
once. To produce hydrogen for fifteen
minutes, press the power button twice.
If you press it again, it will stop.
3. After the chosen amount of time (one
press for nine minutes, two presses for
fifteen minutes), the indicator light will
go off and you’ll hear beeping to let you
know the process is finished.
4. You can drink the water directly from
the tumbler or pour it into another glass.
Unless you plan to seal it in the tumbler
and refrigerate it, you’ll want to drink the
water within an hour.
If the indicator light flashes red,
battery power is low and will need to
be charged. After multiple uses, some
waste water can pool in the bottom
container. Open it and pour out the
waste water.
Do not turn on the power if there is no
water in the tumbler.
Maintenance & Cleaning
Daily Cleaning: Wipe off the tumbler
body. Clean the inside of the bottle
and remove any foreign matter on
the electrolysis plate. To do this, fill the
bottle to half with water, shake several
times, and pour out the water. Close
the cap tightly. Do not use detergent or
other volatile solvents.
Periodic Cleaning: After frequent use,
you should use citric acid to clean the
electrolysis plate to remove scale. Put
5g of citric acid in a half tumbler of
water, let it soak for 1-2 hours, shake it
several times, and pour out the water.
Then you can clean it again with clean
water as you do for daily cleaning. Do
not use detergent or other volatile
solvents.
Odor Treatment: If after long time use a