Propagate PRO PPHTC-1 User manual

Heat Mat Thermostat Controller PPHTC-1
INSTRUCTION MANUAL
QUICK SETUP
1. Place the probe into the desired medium you wish to
control, for seeds/cuttings insert 1” to 1-½” into soil.
For controlling air temperature, you can use the
included suction cup or attach via clip or tape to an
open area away from drafts or cold surfaces.
2. Plug your heating device into the outlet on the bottom
of the thermostat.
3. Plug the thermostat’s power cord into the electrical
outlet. The POWER LED light will turn on.
4. Changing Temperature Setpoint: Press the (SET)
button for 3 seconds until the display numbers
FLASH Press the ‘’(UP) or ‘’(DOWN) arrow
button to adjust the temperature, press the (SET)
button again to set the chosen temperature.
USING THE CONTROLLER
Press and hold ‘’(UP) button to display temperature in
Fahrenheit.
Press and hold ‘’(DOWN) button to display temperature
in Celsius.

When the unit is plugged in, the POWER LED light will be lit.
The heating source (OUTLET PLUG) only has power when
the HEATING LED light is lit.
When the preset temperature is reached, the HEATING LED
light will turn off, and shut off power to the (OULET PLUG).
When the temperature drops 2°F (1°C) below your setpoint
the HEATING LED light will be lit and send power to the
(OULET PLUG).
SPECIFICATIONS & WARNINGS
•Do not immerse controller into water.
•Thermostat has an automatic safety shut-off if probe’s
temperature reaches 108˚F.
•Do not exceed a total of 1000 watts of heating devices
plugged into thermostat.
•ETL listed, Conforms to UL Std No. 60730-1, 60730-2-9.
FCC Certificate #ANL17101009-F
•Temp control range is 34-108°F (1-42°C)
•Rated Voltage is 120VAC 60Hz
•Max Loading: 8.3 Amps –1000 Watts
PROPAGATEPRO.COM
Heezy LLC - 650 NW Bovela Lane #5 - Poulsbo, WA 98370