
Press and hold the Power button for 3
seconds.
Press and hold the Power button for 3
seconds while the camera is not
recording Events.
Double-press the Event button.
Press and hold the Event button for 3
seconds.
Add Marker During an
Event
Single press the Event button while
Event recording.
Mute or Unmute Audio
Recording
Press and hold F1 button for 3 seconds.
Enter or Exit Covert
Mode
Press and hold the F1 and F2 buttons
simultaneously for 3 seconds.
Temporarily Increase
Display Brightness
Single press the power button to
increase the display brightness for 5
seconds.
The display will rotate automatically from docked to operational
mode; it will automatically dim after 10 seconds of inactivity.
Insert the camera into a single or multi-unit
dock to charge the battery and upload files.
The cameras will immediately begin uploading
once connected. The camera display will show
the upload status. Always check the display
before removing a camera from the dock; do
not remove if a firmware update is in progress.
Event recording initiated by button
Event recording initiated by signal from another camera
Event recording initiated by signal from a car
Audio is muted or disabled
Covert mode is enabled (no sounds, vibrations, or LED)
Battery status, changes to red when less than 10%
Battery is charging (when docked)
Pre-Event recording is active
Background recording is active
Camera remote activation signal is broadcasting
F2 Button
Event Button
Speaker
F1 Button
Microphone
Status LED
Power Button
Status Bar
Information Area
Secondary Information Area