Proxicast J-MAX User manual

J-MAX™ ANTENNA MOUNT
ASSEMBLY INSTRUCTIONS
Contents:
A
B
C D E F G
Install Base to Mounting Surface
Install Pivot Bolt Through Top Hole in Base and Pole
A. Base
B. Pole
C. M6 Pivot Bolt
D. M6 Long Lock Bolt
E. M6 Short Adjustment Bolt (x2)
F. M6 Serrated Flange Nut (x4)
G. M8 Lag Screw (x4)
Tools required: M10 & M13 Wrenches
Use the provided lag screws or other
fasteners appropriate for the surface
material.
Pole can be installed in either orientation.
Align the square portion of bolts with the
holes and insert fully.
Do not tighten pivot bolt nut until final pole
position is determined.
© Copyright, Proxicast LLC. All rights reserved.
Contents may vary depending on model - Specifications subject to change without notice.
www.proxicast.com
1
2
3
Rev 20211129

Option 1: Install Angle Adjustment Bolt
Option 2: Install Lock Bolt
Tighten All Nuts
© Copyright, Proxicast LLC. All rights reserved.
Contents may vary depending on model - Specifications subject to change without notice.
www.proxicast.com
To position the pole at an arbitrary angle,
install the 2 short adjustment bolts from
the inside of the pole and through the
curved slot.
To position the pole at 0˚ or ±45˚, insert
the long lock bolt through one of the 3
pre-set position holes in the base.
Prior to installing antennas or other devices
on the pole, check all bolts and tighten all nuts.
4
5
6
Rev 20211129