PS Engineering PM3000 Manual

1 202-193-0001PM3000 Pilot Guide & User Manual
9800 Martel Road
Lenoir City, TN 37772
www.ps-engineering.com
PM3000
High-fidelity, Stereo Intercom System
Pilot’s Guide
Part Number 11931(A), 11932
FAA-TSO
C50c
Also includes 11933A, 11934, non-FAA TSO units
202-193-0001 Revision 3
October 2006
Flying never sounded so good®

202-193-0001 2 PM3000-Pilot Guide & User Manual
Section I General Information
Introduction
The PM3000 is an FAA-TSO approved, panel mounted, 4- to 6-place high-
fidelity stereo intercom system (ICS). Please read this manual completely
before using the unit to become familiar with all its features.
Scope
This Pilots Guide contains operational instructions for the following PS
Engineering unit :
Model Description Part Number
PM3000 4-place intercom system w/pilot iso 11931
PM3000 Same as 11931, with aux audio input 11931A
PM3000 6-place intercom system w/crew 11932
PM3000 4-place w/digital recorder (non-TSO) 11933A
PM3000 6-place w/digital recorder (non-TSO) 11934
NOTE: installation instructions are contained in Installation Manual, part
number 200-193-xxxx, available at your authorized PS Engineering Dealer,
or www.ps-engineering.com/pm3000.shtml
Description
The PM3000 is a 4- or 6-place (depending on model), panel-mounted inter-
com with multiple volume and VOX (voice activated squelch) circuits us-
ing unified volume and squelch controls for the pilot, copilot and passen-
gers.
With few controls for the pilot to use, the operation of the PM3000 is very
straightforward. Yet the unit outperforms its much more complicated com-
petition. Although there is only one volume control knob, when an adjust-
ment is made to the volume control, all output amplifiers are being changed
simultaneously. Likewise, when the squelch control knob is adjusted, sev-
eral VOX circuits are being changed at the same time. Since the system is
designed to use modern stereo headsets, it is not necessary to balance the
volume and squelch controls at the intercom.
The PM3000 has an automatic fail-safe interconnect to the aircraft radios.
If power is disrupted to the intercom for any reason, an internal relay will
connect the pilot's headset to the aircraft radio allowing continued radio
communications.
Provision for entertainment input allows the pilot, copilot and passengers

3 202-193-0001PM3000 Pilot Guide & User Manual
the option to listen to music during flight. During intercom or aircraft radio
reception, this music will automatically mute to allow communications
without distraction. When the activity ceases, the Soft Mute™ circuit
gradually returns the music to the original listening volume. By depressing
the “Mute” control (located on the Squelch knob) once, it is possible to
have the music remain at a constant level, regardless of any ICS or radio
traffic.
During various phases of flight, the degree of importance of the aircraft
radio will vary. Because the "ISO" mode connects the pilot directly to the
aircraft radio, select the "ISO" mode when the pilot must have top priority
on radio transmissions.
Both pilot and copilot have transmit capabilities over the radio. The
PM3000 only allows the voice of the person who presses their PTT to be
transmitted over the aircraft radio. If both pilot and copilot press the PTT at
the same time, the copilot will override. When either pilot or co-pilot
presses PTT, all other microphones are disabled. The pilot can regain prior-
ity by switching the unit off.
Approval Basis
The PM3000, part number 11931(A) or 11932 is FAA-approved under
TSO-C50c, and RTCA, Inc. DO-214. Due to the fact that there is no TSO
for the recorder function in the 11933 and 11934, these units are not fully
TSO-approved. It is the responsibility of the installer to determine the ap-
proval basis for these units.
Specifications
Input power: 13.8 - 27.5 Volts DC
Current Drain: < 200 mA (Externally fused at 1 Amp)
Headphone Impedance: 150-1000 Ω(typical)
Audio Distortion: <1.2% @ 50mW into 150 Ωload
Aircraft Radio Impedance: 1000 Ω(typical)
Mic Frequency Response: ±3 dB, 350 Hz — 6000 Hz
Music Frequency Response ±3 dB, 200 Hz – 15kHz
Unit weight: 12 Ounces (0.34 kg)
Dimensions:1.25" H x 3.00" W x 5.50" D (3.2 x 7.6 x 14.0 cm)
Environmental and technical qualifications: RTCA DO-160C/DO-214
Temperature -20º to +55ºC
License Requirements
None

202-193-0001 4 PM3000-Pilot Guide & User Manual
Section II Operation
PM3000 (11931(A) & 11933A)
Adjusting the Volume (1)
The PM3000 volume control knob adjusts the loudness of the inter-
com and music only. The volume control on the PM3000 does not
affect the volume level of the aircraft radio. This allows the aircraft
radio and intercom volume to be balanced independently. The vol-
ume control affects the music level for the pilot and copilot posi-
tions.
By turning the control clockwise, the audio level will increase. The
PM3000 has individual output amplifiers for each headset in the
system and provides plenty of audio output power. NOTE: Volume
level will not change with the number of headset installed.
PM3000 w/ Crew (11932 or 11934)
1 2
3
4

5 202-193-0001PM3000 Pilot Guide & User Manual
Music # 2 passenger volume in CREW mode (11932 and 11934)
version is a fixed level, and controlled locally by the headphone vol-
ume control or music device.
Adjusting the Squelch Control (2)
This VOX operated intercom keeps all microphone channels off
(silent) while the pilot, copilot or passengers are not speaking. This
reduces background noise from the aircraft. Only when someone
speaks will their microphone turn on, allowing the audio to pass
through the system. Although there is just one squelch control, there
are actually three separate squelch threshold circuits. One circuit
each for the pilot, copilot, and passengers. Only the microphone ac-
tually in use is open, reducing noise in the system.
With the engine running, set the squelch control knob by slowly ro-
tating the squelch control knob clockwise until you no longer hear
the background noise in the earphones. When the microphone is
positioned properly near the lips, normal speech levels should open
the channel. When you have stopped talking, there is a delay of
about one half second before the channel closes. This prevents
squelch closure between words, and helps eliminate choppy inter-
com conversations.
Indicator LED (3)
The green LED in the center indicates green when the unit is turned
on, and changes to red during transmit by either the pilot or copilot.
The LED intensity on P/N 11931A and 11933A may be controlled
by the aircraft dimmer system, if installed, The LED on the
11932/11934 is a fixed intensity.
Mode Select (4)
The center switch is a mode control that allows the pilot to tailor the inter-
com function to suit flight conditions. Regardless of configuration, the
pilot will always hear the aircraft radio. NOTE: If there is a power failure
to the PM3000, or if the power switch is turned off, the copilot will not
hear the aircraft radio. Only the pilot is connected directly to the aircraft
radio.
ISO (Up Position): The pilot is isolated from the intercom and is connected
only to the aircraft radios. He will hear the aircraft radio reception (and
sidetone during radio transmissions). Copilot and passengers will hear
themselves and music but not the aircraft radio traffic.

202-193-0001 6 PM3000-Pilot Guide & User Manual
ALL (Middle position): All parties will hear the aircraft radio, intercom,
and music. However, during any ICS conversation, the music vol-
ume automatically mutes. The music volume increases gradually
back to the original level after communications have been com-
pleted.
CREW (11932, 11934 only) (down position): Pilot and copilot posi-
tions will hear aircraft radio and music number one. Passengers will
only hear other passenger’s intercom, and music number 2. Music
number two will not mute during intercom conversation.
Music Mute Control
Normally, any radio traffic or intercom conversation will mute the
music heard in ALL mode, or for the front in CREW. However,
when the crew desires uninterrupted music, the PM3000 can be
placed in the Karaoke Mode, for singing along. Press the right knob
(squelch) once to activate Karaoke mode, so the music will not be
muted. Press again to restore the SoftMute™ function
Intercom Recorder System (11933A, 11934 only)
The Intercom Recording System is a digital recording system allowing
automatic storage and playback of aircraft radio traffic.
Operating as a continuous loop recorder, (first message received will be the
last heard), the recorder has one minute of recording time or up to 16 mes-
sages. With its own built in VOX circuit, there are no buttons to press to
start recording. The system automatically begins to record the instant the
radio becomes active. Aircraft radio audio applied to pilots headset is re-
corded and only the pilot will hear the playback audio, in one ear.
Operation
Recording is automatic; there is no action required by the pilot. To play
back the last recorded message, simply press the momentary switch associ-
ated with the IRS. Each additional press of the button will play the preced-
ing recorded message. You must wait for the message to finish playing
before accessing the prior message.
To cancel the playback, press and hold the playback button for two sec-
onds. The next time the button is pressed, the next earlier message will be
heard.

7 202-193-0001PM3000 Pilot Guide & User Manual
Section III Warranty and Service
In order for the factory warranty to be valid, the installations in a certified
aircraft must be accomplished by an FAA-certified avionics shop and author-
ized PS Engineering dealer. If the unit is being installed by a non-certified indi-
vidual in an experimental aircraft, a factory-made harness must be used for the war-
ranty to be valid.
PS Engineering, Inc. warrants this product to be free from defect in material and
workmanship for a period of one year from the date of installation. During this one-
year warranty period, PS Engineering, Inc., at its option, will send a replacement
unit at our expense if the unit should be determined to be defective after consulta-
tion with a factory technician.
This warranty is not transferable. Any implied warranties expire at the expiration
date of this warranty. PS Engineering SHALL NOT BE LIABLE FOR INCIDEN-
TAL OR CONSEQUENTIAL DAMAGES. This warranty does not cover a defect
that has resulted from improper or unreasonable use or maintenance as determined
by us. This warranty is void if there is any attempt to dissemble this product without
factory authorization. This warranty gives you specific legal rights, and you may
also have other rights, which may vary from state to state. Some states do not allow
the exclusion of limitation of incidental or consequential damages, so the above
limitation or exclusions may not apply to you.
Factory Service
The PM3000 is covered by a one-year limited warranty. See warranty information.
Contact PS Engineering, Inc. at [phone] or through www.ps-engine.com/
support.shtml, before you return the unit. This will llow the service technician to
provide any other suggestions for identifying the problem and recommend possible
solutions.
Units that arrive for repair without a method of payment will be returned via UPS
COD. PS Engineering will not be responsible for any item shipped via US Mail.
After discussing the problem with the technician and you obtain a Return Authori-
zation Number, ship product to:
PS Engineering, Inc.
Service Department
9800 Martel Road
Lenoir City, TN 37772
[phone] FAX [phone]
www.ps-engineering.com
NOTE: PS Engineering will not be responsible for units returned by US
Mail, or in other than the original packaging.
Units received without either an RMA, or a detailed description of the
problem AND a contact telephone number, will be refused.

202-193-0001 8 PM3000-Pilot Guide & User Manual
PS Engineering, Inc. 2006 ©
Copyright Notice
Copyrighted information in this manual is subject to change without notice. PS Engineering
reserves the right to improve or change the products or contents of this manual, without
notification of any person or agency. The contents of this pilot’s guide may be downloaded,
stored and reprinted for personal use provided that this copyright information is included.
Commercial use is strictly prohibited. For further information contact the Publications Man-
ager at PS Engineering, Inc., 9800 Martel Road, Lenoir City, TN 37772. Phone (865) 988-
9800