Pulsar PSP 30B User manual
PSP 30B Ring
Adapter
Manual
Description
PSP 30B Adapters are designed to mount Krypton and Proton devices on
the lenses of various daylight devices with an external lens diameter of 30
mm.
The bayonet connection allows you to quickly install and remove the
thermal imaging module from the adapter.
The precise positioning mechanism enables the perfect alignment of a
thermal imaging or night image in the field of view of daylight optics to
achieve maximum viewing comfort.
Package Contents
PSP 30B Adapter
Allen keys (S1.5, S4)
User manual
Warranty card
Mounting the Adapter on
the Device
Step 1. Mount the adapter on the optical device
1. Move the lever (5) to the OPEN .
2. It is recommended to degrease the lens body of the optical device (6)
before installing the adaptor (2) onto the optical device.
3. Mount the adapter (2) onto the lens of the optical device (6) as far as it
will go.
Step 2. Adjust adapter lever
1. Move the lever (5) from its initial OPEN position to the CLOSE .
2. Loosen the locking screw (4) with an Allen key (S = 1.5 mm).
3. Tighten the screw(3) with an Allen key (S = 4mm). The clamping force
should be 1.5-2 N·m (13.3-17.7 in-lbs) (can be checked with a torque
screwdriver) to ensure tight operation of the lever(5); while the adapter
should not move relative to the body of the optical device (6). If necessary,
tighten or loosen the screw(3) to operate the lever(5) in the best way
possible.
4. Tighten the locking screw (4) as far as it will go.
Mounting the Thermal
Imaging Module on the
Adapter
Step 1. Mount the thermal imaging module on the adapter
1. Remove the protective cover from the eyepiece of the thermal imaging
module.
2. Align the protrusions on the adapter (2) with the grooves of the mount
assembly (1) of the thermal imaging module and turn the thermal imaging
module counterclockwise as far as it will go.
Step 2. Adjust the display position of the thermal imaging module
1. Loosen the screw (7) with an Allen key (S = 4mm).
2. Turn on the thermal imaging module.
3. Align the image center on the display with the image center of the optical
device by tilting the thermal imaging module.
4. Tighten the screw (7) as far as it will go. The clamping force should be
6.5-7.5 N·m (57.5-66.4 in-lbs) (use the torque screwdriver to check).
5. Move the lever (5) to the OPEN .
6. Align top and bottom display boundaries parallel to the horizontal axis by
turning the adapter with thermal imaging module clockwise or
counterclockwise.
7. Move the lever(5) to the CLOSE .
Legal Compliances and
Disclaimers
The manufacturer reserves the right at any time, without mandatory notice,
to make changes to the package contents, design and characteristics that
do not impair the quality of the product.
For technical support please contact [email protected].
Answers to frequently asked questions about the devices can also be found
in the FAQ section.
Table of contents
Other Pulsar Adapter manuals
