PULSE+ APA200 User manual

www.pulse-audio.co.uk | APA Series User Manual
APA Series Power Amplifiers
APA200, APA500, APA800
SPECIFICATIONS
APA200
APA500
APA800
Output Max per channel @ 4Ω
200W
500W
800W
Output RMS per channel @ 4Ω
100W
250W
400W
Output Max per channel @ 8Ω
140W
340W
540W
Output RMS per channel @ 8Ω
70W
170W
270W
Dimensions
88 x 482 x 270mm
88 x 482 x 340mm
88 x 482 x 340mm
Weight (unpacked)
6.8kg
9.1kg
12.3kg
•19” Rackmount (2U)
•High power output
•Combo XLR/6.3mm jack and RCA inputs
•Speaker, 6.3mm jack and binding-post outputs
•Fan cooled
•Output circuit overload protection
•Mains powered via IEC connector

www.pulse-audio.co.uk | APA Series User Manual
INTRODUCTION
FRONT PANEL
REAR PANEL
Thank you for purchasing this Pulse APA-series power amplifier.
This product is intended to give long term, reliable service in normal usage.
Please read these instructions before use to avoid incorrect operation and outline the functions and controls.
(1) VENTILATION GRILLE- Do not cover or restrict airflow
(2) CHANNEL A+B LEVEL - Attenuate output levels
(3) INDICATOR LEDS - Show signal present, clipping or protect mode
(4) POWER SWITCH - Switches mains power on/off
(5) COOLING FAN - Do not cover or restrict airflow
(6) VOLTAGE SELECTOR - Check voltage switch is in correct position for the mains power supply being used
(7) FUSED IEC MAINS INLET- - to replace fuse, disconnect mains lead & open with flat screwdriver
(8) OUTPUT SECTION Connect speakers using speaker sockets, jack or binding posts
(9) INPUT SECTION Connect mixer or other audio source via combo XLR/jack or RCA L+R

www.pulse-audio.co.uk | APA Series User Manual
CONNECTION EXAMPLE

www.pulse-audio.co.uk | APA Series User Manual
OPERATION
MAINTENANCE
No user serviceable parts inside, refer all servicing issues to qualified service personnel.
Clean case with a lint-free dry or slightly damp cloth, keep ventilation grille and fans clear of debris.
TROUBLESHOOTING
Errors and omissions excepted.
Copyright© 2014. Pulse
Check mains for correct voltage as indicated near to the IEC mains inlet on the rear panel. Connect to mains
supply using the IEC cable provided.
Connect the outputs A+B to speakers via speaker connectors, jack or binding posts, ensuring that the minimum
impedance is no lower than 4 per channel
When using 8 speakers, connect the speakers in pairs to each other and then connect one of each pair to an
amplifier channel output.
Connect the mixer or audio source to either the combo or RCA input sockets
With channel A+B levels down, switch the power on.
Gradually increase channel levels and check for sound from speakers.
If there is no sound, turn down channel levels, switch off and disconnect mains and check connections if front
panel PROTECT LEDs are lit, refer to qualified service personnel.
NO OUTPUT -
Check mains power is on and fuse is OK
Check leads and connections
Check PROTECT LEDs are not lit
Check speakers are working on another amplifier
DISTORTED OUTPUT -
Check the total speaker impedance is not below 4Ω per channel
Turn down the input level from audio source
Check audio source file being played is not distorted
Turn down channel gain controls
If protect mode is active, refer to qualified service personnel