Pure Clean PUCRC45 User manual

PURECLEAN PUCRC45 ROBOTIC
VACUUM CLEANER
USER MANUAL
Check us out online to see tutorial videos and get support!
www.Purecleanhome.com

Components of the cleaner:
Robot Adaptor Charging Dock
Cleaning brush Manual
Parts:

1. Power LED
2. Signal transmitting
3. Charging positive electrode
4. Charging negative electrode
5. Power DC socket
FIRST USE
Install the Docking Station
1. Install the Docking Station on flat ground firmly and against a vertical wall (fixed on the wall
with the Docking Station sticker).
2. Obstacles or hollow areas should be at least 3m away from the front of the Docking Station
and at least 1m away to the right and left (refer to Figure 1).
3. The Cleaner cannot seek the Docking Station for charging if the infrared signal-transmitting
window of the recharger is covered.
4. Connect the output terminal of the adaptor to the DC socket of the Docking Station
5. Place the power cord of the adaptor along the wall, or it may interfere with the Cleaner's
brush or wheels.

First Charge
*IMPORTANT*
Before putting your robot on the charger for the first time –check if the battery is completely
depleted by running the robot. (Make sure the hard power switch on the side is set to the on
position)
Once you have verified the battery is depleted allow the robot to charge undisturbed 5-6
hours before using.
Once fully charged –Completely drain the battery through the first use before allowing the
robot to recharge.
Display Interface
Buttons
“+”
Current/preset time setting
“-”
Power switch
Cleaning mode
Start/pause
Icons Explained
Set one-time cleaning
Preset the cleaning time for a single day.
After finishing this cleaning cycle, the preset
cleaning time will be cancelled.
Continued preset cleaning time
The robot will start cleaning at the preset
time every day
Weekly Schedule
Set cleaning to specific days of the week
Machine trapped
Wheel overhanging
Power showing
Current time
Dustbin is not full
Time
Start/pause
Auto cleaning
Wall following cleaning
Spot cleaning
Auto charging
Indicates cleaning is scheduled
Set Current Time:
(Recommended –go to “ Purecleanhome.com ” and watch the video instead)

Note: The robot is in military time and has no 12 hour mode
Turn on the robot and short press “” about 1 second to enter the time setting status
Press “” or “” to set the numbers
Press ” ” to save the hour setting and go to the minute setting.
Press ” ” to save the minutes setting and move to the preset cleaning time.
-This is the time you would like the robot to activate by itself.
Set Cleaning Frequency Mode:
Press “ ” to cycle through the modes
“ ” one-time cleaning at the scheduled time
“ ” Cleane every day at the scheduled time
“” Follow the weekly schedule to skip days
Set the length of the cleaning time
-Setting longer than a standard battery charge can cause the robot to clean multiple times in one
day.
1. Long press “” for 3 seconds; and wait for the LCD will flicker “--:--“
2. Press “ ” and “” to choose hours
3. Confirm the setting with the “ ” then select the minute
Set a weekly activation schedule
Press “” to choose the ” icon then long press the “” to enter the week day selector
The screen will show “-1:23”
First –set the current day using “ ”
“0”means Sunday, “1” means Monday, ”2” means Tuesday, ”3” means Wednesday, “4”means
Thursday, “5” means Friday, and ”6” means Saturday.
After setting the current day, press “ ”; to continue
Now you will turn off the days you do not want cleaning to occur by pressing “” then “ ” to
confirm your selection and move to the next day