Pure-Fit Spa VM723A Programming manual

EN
Heat Pads
VM723A/VM723A/VM723C/
VM723D/VM723E
Usage and Maintenance Instructions

Usage and Maintenance Instructions Ver. 1 01/2014 (2771)
2
INTRODUCTION
Please read all instructions and warnings on the leaflet supplied inside this box before use.
To reduce the risk of burns, fire and personal injury, this product must be used in accordance
with these instructions and warnings.
KEEP THE E IN TRUCTION IN A AFE PLACE
BEFORE USE
•Carefully remove all packaging. Avoid using any knives or other sharp instruments
as this may damage the product.
•Check the product for any visible damage. If you see any damage or suspect a fault,
do not use your product, but contact your supplier for support.
SAFETY INFORMATION
WARNING: Heat pack can reach up to 54
o
C/129
o
F. Always test on a small area of skin before
applying in full. This product can cause burns. Check skin frequently during use. If you find
irritation or a burn, remove product immediately.
Do not use while sleeping. Consult a doctor before use if you have poor circulation or heart
disease, rheumatoid arthritis or are pregnant.
When using this product: If product feels too hot on skin stop use or apply over clothing. Do
not place excessive pressure, a tight waistband or belt over the product. Do not use for more
than 30 minutes at a time.
Do not use:
•with rubs, medicated lotions, creams or ointments
•on unhealthy, damaged or broken skin
•on areas of bruising or swelling that have occurred within 48 hours without
consulting a doctor
•on areas of the body that don't feel heat
•with other forms of heat
•on those unable to follow these instructions or remove product without assistance,
including children, pets and some elderly users
top use and ask a doctor:
•if you experience any discomfort, burning, swelling, rash or other changes in your
skin that persist where the heat pack is worn or if after 7 days your pain gets worse
or remains unchanged, as this may be a sign of a more serious condition.
ADDITIONAL WARNINGS
•Do not activate heat pack if vinyl is punctured.
•Do not attempt to reset heat pack if vinyl is punctured.
•Never attempt to heat product in microwave.
•Do not ingest contents of heat pack. If contents come into contact with your skin or
eyes, rinse right away with water.
•Keep out of reach of children and pets.

Usage and Maintenance Instructions Ver. 1 01/2014 (2771)
3
TO ACTIVATE HEAT PACK:
1. Flex metal disc back and forth inside heat pack until crystals form.
2. Knead crystals inside heat pack to soften during activation process.
3. Apply heat pack to desired area.
HOW TO REUSE:
1. Carefully place the hardened heat pack into a pan of warm water.
2. Gently simmer the water (do not boil) for 10-12 minutes until all crystals are gone.
3. Let the heat pack cool to room temperature before using again.
WARNING: Never allow pot to boil dry. Never leave heat pack unattended when heating. Do
not use or heat if vinyl punctured. DO NOT HEAT IN MICROWAVE. Keep away from children
and pets.
IMPORTANT INFORMATION
The information given in this instruction booklet must not be taken as forming part of or
establishing any contractual or other commitment by Aidapt Bathrooms Limited, Aidapt
(Wales) Ltd or its agents or its subsidiaries and no warranty or representation concerning the
information is given.
Please exercise common sense and do not take any unnecessary risks when using this
product; as the user you must accept liability for safety when using the product.
Please do not hesitate to contact the manufacturer (detailed below) if you have any queries
concerning the assembly/use of your product.

Usage and Maintenance Instructions Ver. 1 01/2014 (2771)
4
Pure-Fit Sp products re distributed by:
Aid pt B throoms Ltd, L ncots L ne, Sutton O k, St Helens, WA9 3EX
Telephone: [phone] • F x: [phone] • Web: www. id pt.co.uk
Em il: ccounts@ id pt.co.uk • d pt tions@ id pt.co.uk • s les@ id pt.co.uk