Pure H2O QUATREAU SmartTap User manual

SmartTap
QUATREAU™
SmartTap
User Guide

————————————————————
QUATREAU SMARTTAP
USER INSTRUCTIONS
Please read this guide thoroughly
before using your Quatreau SmartTap.
————————————————————
TAP FUNCTIONS:
BOILING WATER WITH TOUCH
SAFETY SEQUENCE
For your safety and to prevent accidental
use, the boiling function has a safety
switch that needs to be released to
activate the flow of boiling water.
1. Depress and hold boiling (red).
2. Depress and release the chilled
button (blue).
3. Fill you cup then release the boiling
(red) button to stop.
2




————————————————————
5.0
TAP FUNCTIONS:
SPARKLING FILTERED WATER
ADJUSTING THE CARBONATION OF THE
SPARKLING WATER
The CO2 is controlled via the gas canister
regulator on the front of the unit (see
diagram)
Use a large flathead screwdriver or a
19mm spanner to increase the level of
carbonation in the water turn the regulator
by a half turn in a clockwise direction.
To decrease the level of carbonation
turn the regulator by a half turn in an anti
clockwise direction.
Between adjustments you must run off
several glasses of sparkling water to
see the effects of the adjustment. If the
sparkling function is spluttering there is too
much gas in the water, reduce the setting
by one full turn and try again.
6
Carbon water lter
CO2gas canister
CO2gas canister regulator
LED lights indicating
boiling water temperature

7
————————————————————
5.1
TAP FUNCTIONS:
SPARKLING FILTERED WATER
CHANGING THE CO2 CANISTER
When the sparkling water tastes flat it is
necessary to change the gas canister.
The integral CO2 gas canister is sited on
the left hand side at the front of the unit
(see diagram opposite).
Please follow the instructions below to
ensure your CO2 canister is correctly
installed:
1 To remove a canister unscrew in an
anticlockwise direction.
2 Locate the thread on the regulator
where the gas canister will connect.
3 Carefully present the canister ensuring
the canister is supported.
4 Rotate the canister in a clockwise
direction being careful not to cross
thread the regulator.
5 Rotate until you hear a hissing sound.
This is the gas being released from
the canister. It is important to keep
screwing until you can no longer hear
this hissing.
6 When the canister cannot be turned
further it is safely connected. Do not
turn the canister any further as this will
damage the regulator.
7 Press the glass icon button and run off
an amount of sparkling water to
re-calibrate the system.
Note:
While removing a canister it is important to
support its weight to avoid the canister
dropping onto the floor.
When attaching a new gas cannister
hand tighten the gas cylinder firmly but
and do not over tighten. Check by
listening that gas is not escaping.
The regulator has an internal opaque
white coloured seal that should stay firmly
in place. Older models have a black
o-ring. If these are removed or fall out the
gas will escape.
The regulators have two cross head
screws attaching the regulator to the front
panel. These are tightened during
manufacture and shuold be checked
periodically at service intervals, if they
come loose gas will escape.

The Pure H2O Company Ltd, Unit 21 Boundary Business Centre, Boundary Lane,
Woking, Surrey GU21 5DH United Kingdom www.quatreautaps.com
QST 0719
Quatreau is a registered trademark of the Pure H2O Company Limited.
Copyright © 2019 The Pure H2O Company Limited. All rights reserved.