
Operation Guide
Cleaning Stainless Steel Plates
If the audible beep goes off and the LED indicator is flashing it is time to
clean the plates (also known as the “Dust Collection Blades or Filter”).
NOTE: There are three (3) fixed stainless steel plates combined into one
single piece. On occasion the unit will produce a faint buzzing noise. This
means the plates require cleaning. Cleaning and re-installation of the plates
as shown here will stop any previous noises heard during operation.
Also in order to remove dust that accumulates on the wires inside, you
periodically turn the unit upside down (do not shake the unit).
TO REMOVE THE PLATES: First, unplug the power cord. Cusp your fingers
under the opening marked “Filter” on top. Gently slide the plates upward out
of the unit housing. Then remove any dust or other contaminants on the
plates with a slightly damp cloth.
IMPORTANT: DO NOT wash plates under a water tap, in a bucket of water
or with a water hose. This can damage the internal components of the
unit when the plates are placed back inside. Only wash with slightly damp
cloth. Once clean, slide the plates gently back Into the unit housing. Plug the
unit back in. You should hear a single beep to confirm the plates are in place
and the unit can be re-started.
UV Lamp Replacement
TO TAKE OFF REAR (GRILL) COVER: First, unplug the unit power
cord. Near the bottom of the rear (grill) cover (side with handle at top)
you will see a plastic tab (as shown in diagram). Gently release the tab
out and then gently push the grill cover down, away from the housing.
TO REMOVE and INSTALL THE UV TUBE: Twist the burnt out tube
90º and pull out from bottom terminal (marked lamp BASE on the
diagram). To install the tube, do the reverse. Place the tube into the
terminals and twist 90º to lock it in.
TO PUT BACK REAR (GRILL) COVER: As shown in the diagram, line
up the arrow on the rear cover with the bottom arrow (marked on both
sides of the unit housing). Then slide the rear cover upward until the
arrow on the rear cover is lined up with the top arrow on the housing.
At the same time, be sure to hold the top of the rear cover with your
other hand and push it up, clicking the rear cover back into the unit
housing.
LAMP LIFETIME: The high efficiency UV lamp will run for about 8,000
hours on average between replacements, or about one year of
continuous operation.
REPLACEMENT UV LAMPS: Use only UVC 15W lamp bulbs which
may be purchased from Purifion Canada or from any authorized dealer.