www.PyleUSA.com4www.PyleUSA.com 5
AC POWER OPERATION
Plug one end of provided AC cord into the AC input jack on the right side of the
amplier. Then plug the other end of AC cord into AC power outlet. Turn on the unit
using the power/volume switch.
NOTE: To avoid damaging your unit, make sure AC power is same as that marked
near AC input jack.
DC POWER OPERATION
This unit can be powered also using extemal12V DC power. Connect external 12V DC
power to DC input jack on top panel of the amplier. Observe the correct polarity as
following.
RECHARGEABLE BATTERY OPERATION
This unit can be powered internally using the built-in rechargeable battery. When AC
power is connected, if battery charging indicator lights red, the rechargeable battery
is not fully charged and will be allowed to charge while the unit is powered by the
AC power. (Note: Turning o the unit power switch will allow the battery to recharge
more quickly.) If the battery charging indicator lights green, the battery is fully charged
and ready to power the unit alone. Shut o the power switch and disconnect the AC
power. Turn the unit back on and the rechargeable battery will power the unit alone.
CONNECTION
The REC OUT socket can be connected to a recording device or to the input jack of a
power amplier to further amplify and enlarge the audio power.
The MIC IN socket can be connected to wired dynamic MIC. Keep MIC head away
from the speaker of main unit to avoid feedback.
WIRELESS BT/MP3 OPERATION
1. Insert ash drive into USB port or Micro SD card into Micro SD Memory Card Slot,
system will play the music in ash drive or Micro SD card automatically. If both
ash drive and Micro SD card are inserted, system will play the music in ash drive.
To play music in Micro SD card press MODE button to switch to SD mode.
2. To play music from your mobile phone etc via Wireless BT, press MODE button to
switch to BT mode. Turn on Wireless BT function of your mobile phone and search
for Pyle Audio and connect. Then you can play your music in mobile phone.
WIRELESS MICROPHONE OPERATION
1. Open the battery cover and install a fresh 9V battery, observing the correct polarity
and then close the cover.
2. Push power switch to ON position. Power indicator will light red, indicating usable
battery strength. In the case of low battery power or a dead battery, the power
indicator either will become dim or not go on at all, indicating that the battery
should be replaced with a fresh one.
3. The RF indicator on the amplier should now be lit.
4. Adjust the wireless MIC volume control of the amplier to a comfortable listening
level as desired.
5. If the microphone is not going to be used for any length of time, push power switch
to OFF position and remove the battery.
ATTENTION:
1. If feedback (howling sound) occurs, try rst turning down the treble control.
If feedback still is present, try turning down the volume or repositioning this unit
with respect to the wired or wireless microphone being used.
2. Extend the antenna fully whenever using the wireless microphone to ensure
optimum performance and maximum range.
