QNAP QM2 Series User manual

QM2 Installation Guide
Unpacking Instructions
Prior to unpacking your QM2 expansion card, ensure that all system requirements are met.
Inspect each item in the packet contents. Contact your reseller for any damaged or missing parts.
Package Contents
QM2 with cooling module;
Low-profile bracket (preinstalled)
Full-height bracket
Low-profile flat bracket

Thermal pad kit
Rubber pad (black) kit
M.2 SSD screw pack

Installing an M.2 SSD onto a QM2 Card
1. Prepare the M.2 SSD
a. Remove protective film from both sides of thermal pad and place thermal pad on SSD
controller.
b. Remove protective film from rubber pad (black) and stick rubber pads on the bottom
side of the SSD as needed.
Note: the thermal and rubber pads work together to transfer heat from the SSD
controller to the cooling module.

2. Unscrew the cooling module from the QM2 board.
3. Remove the cooling module from the QM2 board without disconnecting the power connector.
4. Insert M.2 SSD onto QM2.

a. Insert M.2 SSD into M.2 socket.
b. Secure M.2 SSD with screw.

Note: Ensure that the thermal sensor is in contact with the M.2 SSD.
5. Attach the cooling module to the QM2 board and secure screws.
Installing a QM2 Card in a NAS
1. Power off the NAS.
2. Unplug the power cord from the electrical outlet.
3. Disconnect all cables and external attachments.
4. Remove the screws on the back of the NAS that connect the case cover to the chassis.

Use low-profile bracket
Use full-height bracket
Use low-profile flat bracket
5. Note: Refer to your Hardware User Guide for details.
6. Power off the NAS.

Use low-profile bracket
Use full-height bracket
Use low-profile flat bracket
7. Remove the screw from the PCIe slot cover and then pull the cover off.

Use low-profile bracket
Use full-height bracket
Use low-profile flat bracket
8. Identify the bracket required for your NAS.

Use low-profile bracket
Use full-height bracket
Use low-profile flat bracket
9. Change PCIe bracket on the QM2 card if necessary.