Quarton ML-400 User manual

ML-400 INSTRUCTIONS
OPERATION FUNCTIONS
OPERATION THE ML-400
1. Attach the ML-400 to the cutting machine with four M4 screws (screws not included).
2. When in heavy shock/vibration environments, users can place the rubber buffer between bottom
chassis and surface.
3. Eight magnets are installed in the bottom chassis of ML-400. It will have magnetic attraction when it's
on metal surface with iron.
4. Plug in ML-400 with the Type-C to USB Cable, then connect cable to the USB adapter.
5. USB adapter plug in the outlet and turn on the ON/OFF switch.
6. Loose the fixing screw gently and adjust the module housing to project the laser
line into position you want. Tighten the fixing screw to fix the laser’s position.
7. Loose the fixing ring. Rotate the adjustable bushing to find the angle you want.
Tighten the fixing ring to fix the laser line’s angle.
8. Cut the stuff along the laser line.
Fixing ring
Laser aperture
ON/OFF switch
Module housing
Adjustable bushing
Fixing screw
Screw holes
Type C
female connector
Bottom Side
Magnets
Magnets
3 meters Type C to USB cable
USB adapter
Same as cell phone USB charger

APPLICATIONS
SPECIFICATIONS
Model name
ML-400
Dimension(L X W X H)
4.92”x2.16”x2.36” (12.5 cm X 5.5 cm X 6 cm)
Switch cable : 2.65”(67.5±1cm)
Weight
300±5g / 10.58±0.17 oz.
Wavelength
520 nm (Green)
Width of laser line
<3mm at 5M
Laser class
Class 2M CW mode
Operating temp range
-20°C ~ 60°C / -4°F ~ 140°F
Emitting angle
>120 ﾟ
Housing
Metal
Finishing
Black anodized
Power
Type C (adapter included)
WARNING
Use of controls of adjustment or performance of procedures other than those
specified herein may result in hazardous radiation exposure
SAFETY PRECAUTIONS
Laser radiation is harmful to the eyes, never look directly into the laser beam or its direct reflection
1. Never aim the laser beam at persons’ eyes.
2. This unit must be used by experienced technical personnel only.
Do not leave the laser beam unattended.
3. Do not target vehicles or aircraft with the laser beam when the unit is used
Outdoors.
4. Do not look directly into laser beam with optical instrumentation unless adequate
protective filters are used to protect the eyes.
5. Avoid aiming the laser beam at mirror- likes surfaces. Remove any unnecessary
mirror-likes surface from the vicinity of the laser beam path.
6. The warranty will no longer exist once the product been taken apart.
Stone cutting
Press Brake
Wood cutting
Big pipe alignment
Safety Label
More Information:
https://www.quarton.com/laser-line-generators.htm