R/Evolution Revolution l User manual

8151626
Robotic Pool Cleaner REVOLUTION I
EN Operating Instructions
Robotic Pool Cleaner REVOLUTION I ................... p. 1-8
by

Robotic Pool Cleaner REVOLUTION I | Operating Instructions 1
Contents
1. INTRODUCTION .............................................................................2
2. SPECIFICATIONS ............................................................................2
3. WARNINGS AND CAUTIONS........................................................2
3.1. Warnings................................................................................2
3.2. Cautions.................................................................................2
4. POOL CLEANER PARTS..................................................................3
5. USING THE POOL CLEANER.........................................................4
5.1. Setup......................................................................................4
5.2. Putting the Pool Cleaner into the pool...............................4
5.3. Removing the Pool Cleaner from the pool.........................5
5.4. Maintenance..........................................................................6
5.4.1. Cleaning the filtration system.....................................6
5.4.2. Cleaning the impeller................ ..................................7
5.5. Off-season storage ...............................................................8
Robotic Pool Cleaner REVOLUTION I
Operating Instructions

Robotic Pool Cleaner REVOLUTION I | Operating Instructions
2
Robotic Pool Cleaner BASIC 2
Operating Instructions
1. INTRODUCTION
Thank you for purchasing a REVOLUTION Pool Cleaner.
We are sure that your REVOLUTION Robotic Pool Cleaner will provide you with reliable, convenient
and cost effective pool cleaning. Its reliable filtration in all pool conditions and all-surface climbing
brush enhance maximum pool hygiene.
The Robotic Pool Cleaner deliver advanced cleaning technologys, long lasting performance and
easy maintenance.
2. SPECIFICATIONS
Motor protection: IP 68
Minimum depth: 0.80m / 2.6ft
Maximum depth: 5m / 16.4ft
3. WARNINGS AND CAUTIONS
3.1. Warnings
•Use the originally supplied power supply only
•Ensure the electrical outlet is protected by a ground fault interrupter (GFI) or an earth
leakage interrupter (ELI)
•Keep the power supply out of standing water
•Position the power supply at least 3m / 10ft away from the edge of the pool
•Do not enter the pool while the pool cleaner is working
•Unplug the power supply before servicing
3.2. Cautions
Use the Pool Cleaner in the following water conditions only:
Chlorine Max 4 ppm
pH 7.0 - 7.8
Temperature 6 – 34°C / 43-93°F
NaCl Maximum = 5000 ppm
CAUTION
• Input-100-250ACVolts
• 50-60Hertz
• 180Watt
• Output-<30VDC
• IP54
Digital “Switch-Mode” Power Supply
Power Supply

Robotic Pool Cleaner REVOLUTION I | Operating Instructions 3
Cartridge with ultra-fine filters included filters (x4), net filters optional
There are two filter level options, only one is provided with your robot cleaner. Cartridge with ultra-fine
filter included. Optional net filters for heavy debris.
Power Supply Unit
For concrete, PVC,
fiberglass and liner
PVC Brush
Robotic Pool Cleaner BASIC 2
Brushes
Filtration
4. POOL CLEANER PARTS

4Robotic Pool Cleaner REVOLUTION I | Operating Instructions
GFI/ELI
40°C Max
1
A
2
104°F Max
5. USING THE POOL CLEANER
5.1. Set Up
5.2. Putting the Pool Cleaner into the pool
Shake the Pool Cleaner from side to side or
turn it upside down to release trapped air.
Let it sink to the pool floor.
Position the power supply so
that it is approximately in the
middle of the long side
of the pool at a distance of
3m / 10ft.
Attach the floating cable to the
power supply by inserting it
with the notch on the
connector (1) lined up with
the groove in the socket on
the power supply and turning
clockwise (2).

Robotic Pool Cleaner REVOLUTION I | Operating Instructions 5
Turn the power supply ON.
OFF
5.3. Removing the Pool Cleaner from the pool
The Pool Cleaner will perform automatic shut-off at
the end of the cleaning cycle.
Turn OFF and unplug the power supply.
CAUTION
Using the floating cable, bring the
Pool Cleaner to the pool’s edge.
CAUTION
DO NOT PULL THE POOL CLEANER FROM THE POOL USING THE CABLE.

Robotic Pool Cleaner REVOLUTION I | Operating Instructions 6
Cleaning the cartridge filters
Note: Don’t let the cartridge filters dry out before cleaning.
CAUTION
Unplug the power supply.
With the pool cleaner upside down
open the bottom lid and pull it out.
Click
Clean the filters with a hose.
Open the clips and remove the filters.
5.4. Maintenance
5.4.1. Cleaning the filtration
system:

7Robotic Pool Cleaner REVOLUTION I | Operating Instructions
Insert the filters with the plastic backing
facing out.
Insert the cartridge unit.
If you notice debris trapped in the
impeller open the impeller and remove
the debris.
Place the impeller cover at an angle so that
the notch is on the second ring of the spring.
Press down on the impeller cover in the
direction of the spring, pushing it into place.
Replace the screws.
5.4.2. Cleaning the impeller
Unplug the power supply.

Robotic Pool Cleaner REVOLUTION I | Operating Instructions 8
To remove the
kinks, stretch
the cable out
completely and let
it sit for at least a
day in the sun.
•Make sure that no water is left in the pool cleaner.
•Thoroughly clean the filter bag or cartridge and insert in
place.
•Roll up the cable so that it has no kinks.
•Store the pool cleaner upright in a protected area out of
direct sun/rain/frost at a temperature of between
5˚-45˚C / 41˚-113˚F.
5.5. Off-season storage
If the pool cleaner will not be in use for an extended
period, perform the following storage steps:
Cable
Storage stand optional

Robotic Pool Cleaner REVOLUTION I
8151626
by