2
Safety Instructions
Read the instructions for use carefully before using this product.
•Do not over - inflate your tyres or any other inflatable object.
•Do not leave the compressor unattended.
•Ensure you are safely positioned away from traffic if you have to inflate
a tyre on a road.
•Keep your face a safe distance away from the compressor and the object
being inflated - do not get too close.
•
•Keep out of reach of children.
•CAUTION: Bursting items can cause injury so do not exceed recommended
pressure levels. The cigarette lighter socket should be fused with a 15 amp fuse.
•It is advisable to check the vehicle manufacturers recommended tyre pressures
to ensure correct inflation levels (Keep this information with you in the car).
Features
3
Using your 5-in-1 Air Compressor
Preparation for use:
Before plugging in Compressor/Inflator ensure switch is in
The “OFF” position.
If compressor /inflator does not function, check power
connection is secure.
Note this is normally the first position without the car actually
starting.
Always check that the car is in neutral and the handbrake is on.
This compressor is designed for use with a car 12V DC power
supply, do not connect to any other type of electrical power.
Power connection:
Open the storage compartment in the back of the compressor
(see Dia. 1).
Pull out the air supply cable and the power Plug cord/DC cigarette
lighter plug.
Plug the power cord into the 12V DC cigarette socket.
NOTE: Ensure switch on compressor is in the “OFF” position.
1) Using the Compressor:
Attach the air supply cable (item1, Dia.6) securely to valve on
tyre or other item to be inflated, use adaptors if necessary.
Set the pressure gauge on the compressor to the required PSI
by turning dial until the needle aligns with appropriate pressure
(see Dia 4).
Press air switch to the “ON” position, the compressor will start.
The compressor will inflate the tyre(or other item) to the pre-set
pressure and when reached the compressor will automatically
stop and shut off.
Press the compressor switch to the “OFF” position and
disconnect the air supply cable from the valve.
NOTE: Use a pencil or similar gauge to check the pressure.
2) Auto Cut-Off:
IMPORTANT!
If the tyre is already at a higher pressure than that set on the
gauge the compressor will not start (see Dia. 4).
NEVER rotate gauge dial during operation.
Always double check air pressures using an accurate pressure
gauge.
3)Inflating:
NOTE:Auto cut-off does not function with this feature.
Fit the connector socket (item 3, Dia. 6) to the end of the
red hose then onto the socket on the front of the compressor
Marked “OUT” (see Dia. 5).
Attach the appropriate adaptor required for the item to be
inflated to the red hose and ensure that it is securely fitted.
Plug the power cord into a 12V DC cigarette lighter socket.
You may have to turn the ignition key before starting the
compressor.
This compressor is intended for short run use. Maximum uninterrupted running
time should not exceed 20 minutes and a 20 minute cooling down period is
recommended before running the compressor again.
