-1- -2-
The tool chest is stored inside the
cabinet section for transit purposes.
Unscrew the base from the cabinet
to remove the tool chest
Remove the cabinet base from the
tool chest
Carefully lay the cabinet on its top and
refit base.
Fit the caster brackets to the base of the
cabinet with nuts & bolts supplied. Then
insert castors (Tools not included for
assembly).
BASE AND CASTOR ASSEMBLY
DRAWER REMOVAL
Components
PARTS
NO. DESCRIPTION QUANTITY
Tool chest components
Cabinet components
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
1 PC
1 PC
2PCS
2PCS
1 PC
1PC
1 SET
3 PCS
4 PCS
1 PACK
2 PC
2 PC
1 PCS
LID
LID SUPPORT
SIDE HANDLE
SMALL DRAWER
LARGE DRAWER
LOCK & BAR
LOCK & KEY
PLASTIC
DRAWER PULL
FRICTION SLIDE
CASTOR PACK
DRAWER
PLASTIC
DRAWER PULL
PLASTIC HANDLE
a) Pull the drawer all the way open, then
push it back to align the slide stop
with opening.
b) Push the slide stop in with a screwdriver
as shown until the slide stop clears the
drawer glide.
c) Repeat (b) for the other side and remove
the drawer.
To reinstall drawer
Prise out the slide stop (approx. 1/4”), and
slide the drawer channels back onto the
glides.
Firmly push drawer in until it reaches the
closed position.
MAINTENANCE
Drawer slides and castors should be lubricated periodically with general purpose oil.
Check all screws, nuts and bolts periodically for tightness to maintain trouble free operation.
Safety Instructions
When moving the tool cabinet, ensure all drawers are closed for safety reasons.
Lock the castor when in position to stop unwanted movement during use.
Open one drawer at a time to avoid any possibility of tipping.
