RACING COCKPITS PRO TRIPLE User manual

PRO Series - TRIPLE Monitor Mount
Manual (v.04/2021.1)
If you need any assistance building, please let us know. We are here to help!
T[email protected] +1(833)RACING2
©2021 Racing Cockpits Operating Company, LLC

RCP Cockpit PRO: Parts Guide
Vesa Mounts
Pivot Plates (Right Hand & Left Hand)
2-Slot Profile
4-Hole Joiner Bracket
Page 2
PRO Series - TRIPLE Monitor Mount Manual (v.04/2021.1)

RCP Cockpit PRO: Parts Guide (Cont.)
4-Hole 90° Corner Bracket
2-Hole End Cap
Standard Spring T-Nut
16mm Standard Bolt 12mm SHORT Bolt
Page 3
PRO Series - TRIPLE Monitor Mount Manual (v.04/2021.1)

How to Use T-Nuts: A Quick Guide
Method 1: Simply slide T-Nut into T-Slot from the side.
Method 2: Push T-Nut into T-Slot at an angle then snap into place so it ends up flat. You can
lever the allen wrench in the screw hole to help with this. This method is what you will use
once the ends are blocked.
Page 4
PRO Series - TRIPLE Monitor Mount Manual (v.04/2021.1)

How to Use T-Nuts: A Quick Guide (Cont.)
Once T-Nut is in place, simply secure bracket etc. with the correct length bolt.
PRO TIP: If you are installing vertically and need to hold the T-Nut in place, you can put
the long end of the allen wrench into the T-Slot channel to hold it from below while hand
tightening the bolt to secure it from sliding. Then do final tightening with the allen
wrench.
Page 5
PRO Series - TRIPLE Monitor Mount Manual (v.04/2021.1)

Build Guide
Step 1: Connect Monitor Mount Uprights
Profile:
● 2 x 19” 2-Slot Profiles
Hardware:
● 2 x 4-hole 90° Joiner Brackets
● 8 x 16mm Standard Bolts
● 8 x Standard Spring T-Nuts
Connect 19” monitor uprights to the back of cockpit uprights. TIGHTEN well. These will
hold a lot of weight.
Page 6
PRO Series - TRIPLE Monitor Mount Manual (v.04/2021.1)

Step 2: Add End Caps
Hardware:
● 2 x 2-Hole End Caps
Page 7
PRO Series - TRIPLE Monitor Mount Manual (v.04/2021.1)

Step 3: Add Lower Extender Arm Brackets
● 2 x 4-Hole 90° Corner Brackets
● 4 x 16mm Standard Bolts
● 4 x Standard Spring T-Nuts
Both need to be level with each other. Use a tape measure to ensure they are at the same
height. You will fine tune the height for your monitors in a later step.
Page 8
PRO Series - TRIPLE Monitor Mount Manual (v.04/2021.1)

Step 4: Add Extender Arms
Profile:
● 2 x 10” 2-Slot Profiles
Hardware:
● 4 x 16mm Standard Bolts
● 4 x Standard Spring T-Nuts
Both need to be even front to back with each other. Use a tape measure to ensure they
are mounted at the same distance. You will fine tune the distance to your monitors in a
later step.
Page 9
PRO Series - TRIPLE Monitor Mount Manual (v.04/2021.1)

Step 5: Add Upper Extender Arm Brackets
● 2 x 4-Hole 90° Corner Brackets
● 8 x 16mm Standard Bolts
● 8 x Standard Spring T-Nuts
Page 10
PRO Series - TRIPLE Monitor Mount Manual (v.04/2021.1)