Thread pull
tab onto
bungee cord
Complete the loop by threading
through hole on opposite side of
caddy and tying another knot behind
Add remaining two lengths of bungee
in the same way using holes for each
of the tool / utility pockets
Thread longest length through
hole in top of side and tie a
knot outside of caddy
RAILBLAZA TACKLE CADDY
ASSEMBLY INSTRUCTIONS
BUNGEE INSTALLATION
Cut 800mm
length of
bungee into
1 x 400mm
and 2 x
200mm
lengths
STEP 6:
To prevent elastic from
fraying - wrap the
bungee tightly with one
layer of tape at the
cutting location and cut
in the middle of the
tape
Leave tape on to help
threading through
holes in the next steps
STEP 7: STEP 8: STEP 9:
STEP 10:
MOUNTING HARDWARE
CONSOLE MOUNT:
Use 4 x large
screws to
secure the
Caddy to your
console using
holes in
BACKPLATE
either side of
the Caddy
TRACK MOUNT:
TIP: use the
BACKPLATE as
a template if
you want to
drill pilot holes
Select upper or lower mounting hole on
backplate and thread the trackbolt through
from the back add rubber washer and secure
with hex knob
(optional)
Select your T-bolt
STAR MOUNT:
Requires purchase of
02-4043-11 Attachment
Adaptor
Fit one Male Star
to either side of
the Caddy as
shown choosing
either the upper
or lower hole
•
T Bolt
Can be used on:
Tracker, LOWE, Lund, Early
Crestliner models, War Eagle
and many more
•
•
Can be used on:
RAILBLAZA Gunnel Track
Horizon and Stessl boats
Australia 2020 onwards.
Square Track Bolt
Can be used on:
• Crestliner, SureMount Track
2018 onwards
