RAK RAKBox-B2 User manual

Documentation Center
Installation Guide
Assembly List
Figure 1: Assembly list
Assembly
Step 1: Install the plate with two M4*5 screws.
Figure 2: Installing the Plate
Step 2: Fix the WisBlock IO module with three M1.2*3 screws; For assembly method and precautions, please
refer to RAK5005-O Baseboard Installation Guide.. The figure shows the fixation of RAK1920.
Figure 3: Attaching WisBlock IO
Step 3: Fix the WisBlock module on the plate with M2.5*4 screws.
📝 NOTE
The number of screws is depending on the WisBlock IO module type, please confirm according to the
actual module.

Documentation Center
Figure 4: Attaching WisBlock Module
Step 4: If an external connection is required, for example an external sensor, remove the plug on the longer side
of the enclosure and replace it with the gland. Pull the cable to the external device through the gland and make
sure the lid of the gland is closed properly. If the gland is not closed properly, there is a chance for water and
humidity to enter into the enclosure and damage the WisBlock.
Figure 5: Attaching the Gland
Step 5: Stick the antennas of WisBlock Core module on the inner wall of the enclosure, and the figure below is
only for illustration;
Figure 6: Installing the Antennas to the Enclosure
Step 6: Install two M2.5*15+6 hexagon standoffs for the battery plate.

Documentation Center
Figure 7: Installing standoff screws
Step 7: Plug the battery cable into the socket on the PCB (if the solar panel enclosure is used, connect the cable
of solar panel to the PCB), and then fix the battery plate on the standoff with two M2.5*4 screws.
⚠ WARNING
Be sure to connect the battery and solar cable first, otherwise the cable cannot be connected after
installing the battery plate.
Figure 8: Attaching battery and Solar Panel
Step 8: Stick the battery on the battery plate with double side adhesive stickers.
Figure 9: Attaching the Battery
Step 9: Close the cover, tighten the screws and complete the assembly.

Documentation Center
Figure 10: Attaching the Cover
Installation
Wall Mounting
Step 1: Fix the installation kit on the bottom of the enclosure with four M5*10 screws. Make sure that the Z-shaped
mounting bars are extruding from the enclosure as shown in the image.
Figure 11: Installing the Bracket
Step 2: Using a Ø5mm drill bit, drill 4 holes on the wall according to the dimension of the following picture and
then plug the screw anchors in the wall.
Figure 12: 4 Drill Holes
Step 3: Fix the enclosure with the 4 screws to the wall.

Documentation Center
Figure 13: Attaching the Enclosure to the Wall
Pole Mounting
Step 1: Fix the installation kit on the bottom of the enclosure with four M5*10 screws. Make sure that the Z-shaped
mounting bars are NOT extruding the enclosure, as shown in the image.
Figure 14: Attaching the Installation Kit
Step 2: Slide the Steel band clamp through the rectangular hole of the mounting bar, wrap the band clamps
around the pole, lock them and then tighten the clamps using a screwdriver.
Figure 15: Attaching the Clamp to the Pole
Last Updated: 10/11/2021, 4:28:25 AM