Rancilio Silvia E Owner's manual

Copyright 2007-2016,Auber Instruments Inc.All Rights Reserved.
No part of this manual shall be copied, reproduced, or transmitted in any way without the prior,written consentof Auber Instruments.Auber Instruments retains theexclusive rights to all information included in this
document.
SupplementalInstallationGuideforSilviaE
KIT‐RSRTDNb
(April2016)

ThisisasupplementalguideforRancilioSilviaE,releasedonthewinterof2015forEuropeanmarket.
SincethechangesofSilviaEareverylimitedfromSilviaV4,thisguideonlycovertheinstallationsteps
thatneedtobeadjustedduetothesechanges.
Theonlydifferenceisthatthetappingofpowerisdifferent.ThemainpowerswitchoftheSilviaEhas
changedfromtheoriginalmechanicalON/OFFswitchtoapushbuttonresetswitch.Therefore,wehave
totapthepowerfromthebrewswitch.
Usershouldstilluse“KIT‐RSRTDNInstallationguideV2.2”asthemaininstallationguide.

1. TappingthePowertotheController
ReplacetheoriginalbrewthermostatwiththeRTDStat(pointedbythebluearrowinFigure1).Thenwe
willtaptwocablesonthebrewswitch(pointedbygreenarrowsinFigure1)tosupplypowertothe
controller.Thegreenarrowspointtoaredandablackcableconnectedtothelowertwobladesonthe
brewswitch.


Figure1.Cablesneedtobetappedarepointedbygreenarrows.

First,removeallfourcablesonthebrewswitch.Connectthetwoblackcableswithpiggyback
connectorstotheredandblackcableremovedfromthebrewswitch.

Next,putthepiggybackconnectorontheredcabletothelowerleftbladesofthebrewswitch.Putthe
otherpiggybackconnectorontheblackcabletothelowerrightbladeofthebrewswitch.
Thenputtheorangecablebacktoitsoriginalposition,whichisthetopleftbladeonthebrewswitch.
Alsoputthewhitecablebacktoitsoriginalposition,whichisthetoprightbladeonthebrewswitch.
PleaseseeFigure4andFigure1forreference.


Figure2.Connectpiggybackconnectorsonblackcablestotheredandtheblackcablesfromthebrew
switch.


Figure3.Puttheredandtheblackcablebacktothebrewswitch.



Figure4.Puttheorangecablebacktoitsoriginalpositiononthebrewswitch.


(End)








Copyright 2007-2016,Auber Instruments Inc.All Rights Reserved.
No part of this manual shall be copied, reproduced, or transmitted in any way without the prior, written consent ofAuber Instruments.Auber
Instruments retains the exclusive rights to all information included in this document.