R&B Wire Products 100 Series User manual

[e-mail][phone] RBWIRE.COM
ASSEMBLY INSTRUCTIONS
R
STEP
1
STEP
2
TOOLS REQUIRED:
(2) 7/16 wrenches or sockets
(1) Large flathead screwdriver
1 person assembly
Setbase upside down with legs pointing up to install
casters. Place raceway cover onto caster stem and insert
caster stem into base leg. While holding raceway cover
up against caster, insert a hex head bolt into each leg
hole, and secure with nuts facing toward inside of unit.
Repeat with remaining casters.
NOTE: Although this instruction sheet depicts the 100 series cart,
it also applies to the 100, 200, 201 and 350 series.
Place basketon base and align holes in bottom of
basket with holes in top of base. Insertflathead bolts
through hole in basketand through base, and secure
with nuts. Tighten until bolt head engages nylon lock
on nut.
NOTE: Your laundrycart is assembled and readyforuse. Ifyou purchased
the Single Pole Rack or Double Pole Rack accessories, continue to page 2.
WARNING
!
100, 200, 201, 350 SERIES
Wire Cart
· Never allow children or adults to ride in or on
cart, as itcan cause serious injury or death.
· Be sure casters roll freely and turn easily.
· Place all loads in center of basket for balance.
HARDWARE INCLUDED (Notto scale)
x4 Raceway covers
x12 Nuts
x4 Flathead bolts
x8 Hex bolts

[e-mail][phone] RBWIRE.COM
ASSEMBLY INSTRUCTIONS
R
STEP
1
STEP
2
Slide pennant head onto vertical upright, with head
facing toward basket. Secure with short hex bolt and nut.
STEP
2
pg 2
STEP
1
Position vertical rack pole so end with two holes is on
bottom. Thread through inside of basketso itsits on
outside of base. Line up holes and attach with long
hex bolts and nuts. Tighten until bolt head engages nylon
lock on nut.
Single Pole Rack Assembly:
Double Pole Rack Assembly:
100, 200, 201, 350 SERIES
Wire Cart
Install vertical rack poles so end with two holes is on
bottom and poles bend outward. Thread through inside
of basket so they sit on outside of base. Line up holes
and attach with long hex bolts and nuts. Tighten
until bolt head engages nylon nut. Repeat for both sides.
Place crossbarbetween vertical rack poles and position
so tabs at end of crossbar are pointing up. Secure with
short hex bolts and nuts at each end.
HARDWARE INCLUDED (Not to scale)
x3 Nuts
x2 Short hex bolts
HARDWARE INCLUDED (Not to scale)
x6 Nuts x4 Long hex bolts
x2 Short hex bolts
x1 Long hex bolt
*IMPORTANT*