Rapsodo MLM 1.0 User manual

MOBILE LAUNCH MONITOR
user manual
Powered by: Rapsodo
Model No.: MLM 1.0

What’s in the box
Unit Overview
Compatible Platforms
Powering and Charging
Connecting the Wireless
Hitting Your First Shot
Hitting Diagram
Care Instructions
Troubleshooting
Specifications
Downloading the Application
Warranty and Support weight
1
2
3
4
5
6
7
8
9
10
11
12
contents
Getting Started
Getting to know the MLM App 6
1

MLM Device USB Charging
Cable
Quick Start
Guide
Protective Case
what’s ınsıde the box

USB Port
for charging
LED
Indication
Phone/Tablet
Holder
On/Off
Button
overvıew
1
2
3
4

The MLM contains an internal lithium ion battery.
The battery can be charged by connecting the included USB cable between
the USB type C port on the device (located on the right side of the device)
and your computer’s USB port.
The battery should be charged for 6 hours before using the device for the first time.
The device LED will show AMBER indicating the device is being charged
The LED indication will switch off indicating the unit has been fully charged.
The LED indication will blink red indicating the battery charge is getting low and
internal battery should be recharged
Under normal operating conditions, a new battery should last 8 hours on a full charge.
Charging the device
USB Type C
Port
1

GREEN
READY TO TAKE SHOT
red
SWITCH ON UNIT. UNIT
WAITING TO CONNECT TO APP
PAIRING THE DEVICE
1.
2.
3.
On your mobile device, turn on Bluetooth feature.
Make sure that MLM unit is powered on.
When LED on MLM turns red, start the MLM
application on your mobile device. You can go to
[website] to download the application.
Once the MLM unit detects the connection from
the application, the LED will turn green.

distance:
aprox. 8 ft
DEVICE PLACEMENT AND SETUP
1.
2.
3.
Once the MLM unit is connected and displays the
green LED, place the golf ball or tee approx. 8 ft
away from the unit.
Make sure the MLM unit is placed on the same
level as the hitting surface.
When the ball is hit, LED blinks green and you can
view your data in the application.
4. The LED will turn green again when the unit is
ready for you to hit your next shot

aprox. 4 INCHES
Place MLM above the mobile
device to calibrate.
calıbratıon

When charging, Power
LED does not come on
Press the Power button and hold for 5 seconds. Make sure
the USB cable has power. Try other ports on your
computer or change the cable.
Battery is low. Connect the USB cable and charge the unit.
The Power LED will turn GREEN when the unit is charged.
Make sure to start the application AFTER turning on the
Tracer unit. The Tracer unit LEDs show connected only
when the application is open.
Be sure to position the ball correctly about 2 to 3 meters
from the Tracer unit and make sure the unit sits level with
the hitting surface.
Power LED is red and
unit turns off after 15
seconds
LED is not
turning green
Results seem
inaccurate
Troubleshooting table

Carry
Total distance travelled from impact
to landing. MLM estimates this based
on your initial launch conditions,
a level surface is assumed.
Club Head Speed
Speed of your club moments before
impact
Ball Speed
Exit speed of the ball immediately
after impact
Smash Factor
Ball Speed divided by club speed. The
higher your smash factor, the more
efficiently you transfer energy from
club to ball.
Launch Angle
Angle of your ball relative to the ground.
Combined with ball speed, will be main
components to determine shot distance.
Launch Direction
Measure how far from ideal line your shot
lands. Center of your camera assumed to
be zero degrees.
Specifications (WIP)