Razor GROUND FORCE DRIFTER User manual

Need Help? Visit our web site at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM PST.
1
WARNING
Tools Required: (Not included)
A. 5 mm Allen wrench
B. 10 mm wrench
C. Flat head screwdriver
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect charger
before removing or installing the on/off switch. Failure to follow these steps in the correct order may
cause irreparable damage.
Step 1
Figure 1
Loosen the four (4) 5 mm seat bolts and
remove seat.
Step 2
Figure 2a Figure 2b
Loosen the four (4) 5 mm hex bolts on the battery
cover (2 on each side) and remove cover.
GROUND FORCE®DRIFTER™
ON/OFF SWITCH
INSTALLATION INSTRUCTIONS
W13112445101

Need Help? Visit our web site at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM PST.
2
Step 6
Step 3 Step 4
Figure 4
Disconnect the two (2) red wires going from
the control module to the on/off switch and the
single black wire from the on/off switch to the
charger port.
Step 5
Figure 5
Using a flat head screwdriver; carefully remove
the silicone from the back of the on/off switch and
remove from battery cover.
Note
Figure 6
Place replacement on/off switch in the battery cover.
Re-connect the wires as shown above. NOTE: The two (2)
red wires from the on/off switch go on the two (2) silver
prongs (in any order). The black wire from the charger
port goes on the gold colored prong.
(1) Gold prong -
black wire
charger port
(2) Silver prongs -
red on/off switch
Reverse steps 1 through 4 to install the replacement on/off switch.
ATTENTION: Charge battery 12 hours before initial use.
Figure 3
Locate the white plastic connector on the battery
and disconnect it from the control module.
150209