RC4WD Rock Crawler Installation guide

Rock Crawler 2.4ghz Basic Instruction
Manual
Thank you for your purchase. Welcome to the RC4WD family. This radio system is
a combination of many specially engineered and manufactured parts. Please take
time to read this manual in is entirety.
Install your batteries into the transmitter
•Remove the battery cover in the direction of the arro on the cover
•Load your ne AA size batteries. Pay close attention to the polarity
markings and insert accordingly.
•Slide the battery cover back onto the case.

Function S itches
1. Antenna
2. Steering Reverse
3. Steering Trim
4. Throttle Trim
5. Throttle Trigger
6. Steering Wheel
7. On/Off S itch
8. Throttle Reverse
9. Battery Monitor
10. Third Channel Reverse
11. Non Functionsal
12. Non Functional
13. Third Channel S itch

1. Binding button
2. Working Indicator
3. 3rd channel
4. 2nd channel Throttle
5. 1st channel Steering
6. Battery
Transmitter Adjustments
A. Throttle Trigger
1. Push the trigger for ards to allo the vehicle to slo do n or stop.
2. Pull the trigger back ards to allo the vehicle to go for ard and speed up.

B. Steering Wheel
1. Turn the steering heel to the left or right to let the vehicle to turn left or right.
Throttle Trim is used to slightly trim the throttle servo hen the trigger is at neutral
position.
Steering Trim is used to slightly trim the front steering heels
Note: If the front heels are not straight hen the trigger is set at neutral position,
you can adjust the steering trim to make them aligned.
Connecting
As you operate the unit for the first time, the transmitter and receiver need to check
for signal. Follo these steps.
1. Turn on the receiver po er, press the SW s itch. At the same time the
receiver's red LED ill begin to flash.
2. Turn on the Transmitter
3. The flashing red LED on the receiver becomes bright all the time. This
means the signal bet een the transmitter and receiver is connected.
The unit is no ready to use.

Warning before use
An RC Mo el is not a toy. If misuse , it can cause serious bo ily harm an amage to
property an people. Operate only in open areas, following all instructions inclu e here.
This is a sophisticate hobby pro uct an not a toy. It must be operate with caution an
common sense an requires some basic mechanical ability. Failure to operate this pro uct
in a safe an responsible manner coul result in injury or amage to the pro uct or people
an other property. This pro uct was not esigne for use by chil ren without close a ult
supervision. Please make sure to rea over all safety warnings before operating this
pro uct.
Damage Limits
RC4WD shall not be liable for special in irect or consequential amages, loss of profits
or pro uction or commercial loss in any way connecte with the pro uct, whether such
claim is base in contract, warranty, negligence, or strict liability. Further, in no event
shall the liability of RC4WD excee the in ivi ual price of the pro uct on which liability
is asserte . As RC4WD has no control over use, setup, final assembly, mo ification, or
misuse, no liability shall be assume nor accepte for any resulting amage or injury. By
the act of use, setup or assembly, the user accepts all resulting liability.
If you as the purchaser or user of this pro uct are not prepare to accept liability
associate with this pro uct, you are a vise to return this pro uct imme iate in new
unuse con ition to the place of purchase.
Warnings, Precautions an Safety
As a user of the pro uct, you are solely responsible for operation it in a manner that oes
not en anger yourself an others or result in amage to the pro uct or the property of
others.
Carefully follow the irections an warnings for this an any optional support equipment
(chargers, batteries, an battery packs, etc) that you use.
This mo el is controlle by a ra io signal that is subject to interference from many
sources outsi e your control. This interference can cause momentary loss of control so it
is necessary to always keep a safe istance in all irections aroun your mo el, as this
margin will help to avoi collisions or injury.
•Always operate your mo el in an open area away from cars, traffic, an people.
•Avoi operation your mo el in the street.
•Never operate your mo el in populate areas.
•Never operate your mo el with low transmitter or receiver batteries.
•Keep this an all electrical items out of reach of chil ren
•Avoi water exposure to all electrical equipment. This pro uct was not esigne
an protecte from this purpose