rConix SlinkE2 User manual

SlinkE2 Quick Start rev 1.0 Page 1
Receiver Configuration and Connection
 Turn on Transmitter & Receiver
 Open Device Explorer from Model menu
 Select receiver from list
 Connect SlinkE to Ext port on receiver
(E1 or E2 on REX)
Note some R4L US receivers are incorrectly
labelled – Ext is on port 3/usb
SlinkE
2
S.BusforEXBus
+
–
A
For EX Receivers:
 Set Serial Link to EX Bus
For REX Receivers:
 Select Alternative Pin Config
 Set OutPin E1 or OutPin E2 to EX Bus
 Connect S.Bus device cable to “A” port on SlinkE2
SlinkE2
S.BusforEX Bus
+
–
A
To S.Bus
device
SlinkE2 Quick Start Guide
rConix

Power Connections
Avoid drawing high currents from Jeti receiver EXT port !
SlinkE2 is rated for 3.5A continuous current, but the EXT port on many Jeti
receivers (and Central Boxes) is only rated for ~100mA or less.
Arrange power connections so that high currents are not passed through the
Jeti receiver ports.
S.Bus
Hub
SlinkE2 Quick Start rev 1.0 Page 2
Flight Controller
SlinkE
2
S.BusforEXBus
+
–
A
SlinkE
2
S.BusforEXBus
+
–
A
SlinkE2 Quick Start Guide
rConix

SlinkE2 Quick Start Guide
S.Bus
Hub
Flight Controller
SlinkE2 Quick Start rev 1.0 Page 3
SlinkE
2
S.BusforEXBus
+
–
A
SlinkE
2
S.BusforEXBus
+
–
A
SlinkE
2
S.BusforEXBus
+
–
A
rConix

SlinkE2 Quick Start rev 1.0 Page 4
SlinkE2 Configuration using Jetibox
 Use down arrow button to enter SlinkE2 menu
 From Tx, select Applications… Jetibox
 Use left/right arrow buttons to Mx
 Use up/down arrow buttons to change between different settings
 Use left/right arrow buttons to adjust settings
Changes to settings take effect immediately, and are stored in memory.
Available settings are shown below:
SlinkE2 Quick Start Guide
rConix
Failsafe:
 Off
 Hold last
Speed:
 Normal 14ms
 High 7ms
Polarity:
 Normal (inv)
 Reversed