Remington DURABLADE MB050 User manual

DuraBlade
MB050

2
Thank you for buying your new Remington® product. Please read these
instructions carefully and keep them safe.
Remove all packaging before use.
F IMPORTANT SAFEGUARDS
1 This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been supervised/instructed and
understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be done by children unless they are
older than 8 and supervised. Keep the appliance and cable out of reach of
children under 8 years.
2 Suitable for use in a bath or shower.
3 This appliance should never be left unattended when plugged into a power
outlet, except when charging.
4 Do not use attachments other than those we supply.
5 Do not twist or kink the cable, or wrap it round the appliance.
6 Do not use the appliance if it is damaged or malfunctions.
7 If the supply cord of this unit becomes damaged, discontinue use
immediately and return the appliance to your nearest authorised
Remington® service dealer for repair or replacement in order to avoid a
hazard.
8 Do not plug or unplug the appliance with wet hands.
9 This appliance should be supplied with approved safety isolating
adaptors PA-0510E (for Europe), PA-0510U (for United Kingdom) with the
output capacity of 5.0 Vdc; 1A (adaptor output).
ENGLISH

3
CKEY FEATURES
1 On/Off switch
2 Blade
3 Combs (1, 2, 4, 6 mm) (not shown)
4 LED charging indicator
5 USB charging cable
CGETTING STARTED
,CHARGING YOUR APPLIANCE
,Note: It is recommended to fully charge your appliance before using for the
first time. Please refer to the charge times shown in this book.
• Ensure the product is switched off.
• Connect the product to the USB cable and then connect the USB end of the
cable to a powered USB port.
ENGLISH
GBDNLFEIDKSFINPSKCZ
HUN
PLRUTRROGRSIBG HRUAAE
5
1
2
4

4
,CHARGE LEVEL INDICATORS
Charge Level Indicator
Charging LED shows solid
Low charge LED flashes rapidly
Full charge LED will turn off
• Run time from fully charged is up to 60 minutes.
• Charge time from empty is 4 hours.
,Note: To preserve the life of your batteries, let them run out every 6 months
then fully charge.
F INSTRUCTIONS FOR USE
• Switch the product on by pressing the On/Off switch.
• Always comb your beard or moustache with a fine comb before you start
trimming.
,ATTACHING AND REMOVING THE COMBS
•Select the desired trimming length comb. Place the comb over the top of the
blade and gently push this down onto the blade until it clicks into place.
• To remove the comb, grasp the comb and pull firmly upwards and away from
the groomer.
,TO TRIM THE BEARD
•Select your desired trimming length comb. If you are trimming for the first
time start with the maximum trimming length setting.
• Turn the unit on.
• Place the flat top of the fixed comb against the skin.
• Slowly slide through the hair. Repeat from different directions as necessary.
• If hair builds up in the trimmer comb during the trimming process, switch
the unit off, pull off the comb and brush the hair off.
,TO GET A SHAVEN LOOK
•To trim any length of beard or stubble hair for a clean, shaven look then
follow the above steps without a comb attached to the blade head.
• Place the flat top of the blade against the skin and slowly slide through the
hair against the direction of growth.
ENGLISH

5
,TRIMMING AND EDGING
•Hold the groomer with the back side of the blade facing you with no
combs attached.
• Start with the blades resting lightly against your skin, use motions towards
edge of beard line to trim to desired locations in facial area.
• Shape as desired.
,TRIMMING WITH SHAVING GEL
•Follow the same instructions as dry shaving if using shaving gel.
,Caution: After use with shaving gel, please rinse the blade under warm
water to clean away any excess gel and debris.
• To keep the unit in optimal condition we recommend re-oiling the blades
after cleaning. Place a few drops of cutter or sewing machine oil onto the
blades. Wipe off excess oil.
C CARE FOR YOUR GROOMER
• To ensure long lasting performance of the groomer, clean after each use.
BATTERY REMOVAL
• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when
removing the battery.
• Ensure the trimmer is discharged of all power.
• Remove the comb attachment.
• Detach the blade head.
• Pry off the bottom gap below the grips.
• Press in exposed tabs and pull internal frame out.
• Disconnect the battery from the circuit board and internal frame.
• The battery is to be disposed of safely.
H ENVIRONMENTAL PROTECTION
To avoid environmental and health problems due to hazardous
substances in electrical and electronic goods, appliances marked with
this symbol must not be disposed of with unsorted municipal waste,
but recovered, reused or recycled.
ENGLISH
GBDNLFEIDKSFINPSKCZ
HUN
PLRUTRROGRSIBG HRUAAE