Remington XR1410AU User manual

2 YEAR WARRANTY
To register your product go to
remington-products.com.au
remington.co.nz
XR1410AU
USE & CARE
MANUAL
PLEASE READ
PRIOR TO USE
QUICK SHAVE
ROTARY SHAVER

2
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic precautions should
always be observed, including the following.
READ ALL INSTRUCTIONS BEFORE USING
For additional protection, the installation of a residual
current device (rcd) having a rated residual operating
current not exceeding 30 mA is advisable in the electrical
circuit supplying the bathroom. Ask your installer for advice.
WARNING: To reduce the risk of burns, electrocution and
fire or injury to persons.
DANGER: As with most electrical appliances, electrical
parts are electrically live even when the switch is off.
• The appliance should never be left unattended when plugged
into a power outlet, except when charging the appliance.
• This appliance should not be used by children or other
persons with reduced physical, sensory or mental capabilities
or lack of experience and knowledge unless they have
been given supervision or instruction concerning use of
the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning
and use maintenance shall not be made by children without
supervision.
• Never operate this appliance if it has a damaged cord or
plug, if it is not working correctly, if it has been dropped or
damaged, or dropped into water. If the supply cord or plug
of the appliance is damaged it must be replaced by the
manufacturer, its service agent or similarly qualified persons
in order to avoid a hazard. It cannot be repaired. Keep the
cord away from heated surfaces.
• Charge, use and store the product at a temperature between
0°C and 32°C.

3
• Do not use outdoors or where aerosol (spray) products are
being used, or where oxygen is being administered.
• Do not use this appliance with damaged or broken tracks or
cutters, as injury may occur.
• Do not plug or unplug the appliance with wet hands.
• For household use only.
• Do not place or store the appliance or charging adaptor
where it can fall or be knocked into a sink or bath.
• Do not place in or drop into water or any other liquid.
• If an appliance falls into water, “unplug it” immediately. Do
not reach into the water.
• Unplug the charging adaptor from the electrical outlet
immediately after fully charging.
• Unplug and switch off this appliance before cleaning it.
• Use this appliance only for its intended use as described in
this manual.
• Do not use attachments not recommended by Remington.
• Never drop or insert any object into any opening of this
appliance.
• Always store the charging adaptor in a moisture-free
location.
• Do not use on people who are asleep.
• Do not use an extension cord or a voltage converter with this
appliance.
• Do not wrap the cord around the appliance.
Remington strongly recommends that an approved Safety Switch
(residual current device) be installed to protect all bathroom power
outlets. Ask an electrical contractor for advice.
SAVE THESE INSTRUCTIONS

4
XR1410AU QUICK SHAVE ROTARY SHAVER USE & CARE MANUAL
Thank you for purchasing your new Remington®Quick Shave Rotary Shaver.
Inside this manual you will find tips on using and caring for your shaver.
5
6
4
3
1. On/Off Switch
2. Shaving Heads
3. Pop Up Trimmer (Not Shown)
4. 360° Pivoting Neck
5. LED Battery Indicators
6. Charging Pins
Also Includes:
• Head Guard
• Storage Bag
• Cleaning Brush
• Power Adaptor
KEY PARTS
2
1

5
XR1410AU SPECIFICATIONS
Power System Cordless
Full Charge Time 4 Hours
Cordless Run Time 45 Minutes
Indicators LED Battery Indicators
Voltage Type Worldwide 100 - 240V
Shaver Head Replacement Part No. SPR-XR1410AU
Power System
The XR1410AU shaver can only be used without the power cord. The shaver will not
run while it is charging.
LED Battery Indicators
Lights display the battery charge level
• Low Charge: Top LED light will glow solid red to indicate the shaver needs to
be recharged. There is less than 5 minutes of run time remaining.
• Charging: Bottom LED light will glow solid green to indicate the battery is
taking a charge.
• Full Charge: When fully charged the green LED light will go off.
Worldwide Voltage
Shaver automatically adapts to an outlet voltage between 100V and 240V.
NOTE: Some countries will require the use of a plug adaptor that is not
included with your shaver.

6
CHARGING
1. Plug power cord adaptor into the shaver.
2. Plug the adaptor into the wall outlet.
3. Fully charge your shaver for 4 hours before its first use. This first charge is
important to the shaver’s battery life.
NOTE: During the initial charge ignore the electronic indicators as they are in “Start
Up Cycle”.
CAUTION:
• Make sure the shaver and your hands are dry when charging the shaver.
• Always charge the shaver in a cool, dry place.
SHAVING
1. Press power button to turn on.
2. Shave face and neck using short, circular strokes.
3. After shaving, turn the shaver off.

7
SHAVING TIPS
• Remington Quick Shave Rotary Shaver is waterproof. You may use shaving
foam or gel with your shaver. You may also shave in the shower.
• Wait at least 15 minutes after getting up before shaving, to ensure your face
is free of puffiness that may be present from sleeping.
• Always hold the shaver at a right angle to the skin so that all three heads are
touching the skin with equal pressure.
• Stretch skin with the free hand so hairs stand upright, making it easier for
them to enter the cutting chamber.
• Use moderate to slow, circular stroking movement.
• The use of short, circular motions in stubborn areas may obtain a closer
shave, especially along the neck and chin line.
• Do not press hard against the skin to avoid skin irritation and/or damage to
the rotary heads.
NOTE: When using the shaver with foam or gel it is important to rinse the cutting
head clean after each use. This will avoid having the foam or gel dry in the cutting
head and clogging the shaver.
TRIMMING
POP-UP TRIMMER:
1. Pull down the pop up trimmer release button to engage trimmer (Diagram A).
2. Trim and shape sideburns and facial hair to the desired length and shape.
3. Close trimmer by pressing down (Diagram B).
AB
NOTE: Lubricate teeth with oil every 6 months.

Article Price each
AUD
Price each
NZD Qty Amount
$
Face Saver: Pre-shave Powder Stick
SP4 SP5 $11.95 AUD $14.95 NZD $
$ $ $ $
Sub Total
Postage &
handling
TOTAL
7.50
R
Shaver Saver: Aerosol Spray Cleaner
eplacement
Shaving Heads & Cutters for XR1410AU
SPR-XR1410AU
$11.95 AUD $39.95 AUD
$14.95 NZD $44.95 NZD
Remington is a Registered Trademark of Spectrum Brands, Inc., or one of its subsidiaries.

CLEANING & MAINTENANCE
NOTE: When cleaning your shaver, make sure the shaver is turned off and
disconnected from the power cord.
The shaver is a washable appliance. The head and body may be cleaned under warm water.
CAUTION:
• When cleaning the external surfaces of the shaver, do not use strong
detergents or other chemicals.
• To dry, wipe the surface of the shaver with a dry towel. Do not use a hair dryer
or heater to dry the shaver.
NOTE: The shaver head and neck assembly is designed to be detachable from the
shaver body. Simply pull upwards from the neck of the shaver for easy release.
To reattach the neck, align it with the neck attachment cavity so that it clips back
into position.
CLEANING YOUR SHAVER
DAILY CLEANING
1. Locate the detachment grooves on the head & cutter assembly. Gently pull to
detach the hair pocket from the neck assembly (Diagram C).
2. Tap out excess hair shavings (Diagram D).
3. Rinse the head of the shaver in running water.
4. Gently reattach the hair pocket to the neck assembly until it locks in place
on all three sides. The hair pocket may be reattached in any configuration
(Diagram I). 10
SHAVER PARTS
1. Head & cutter (hair pocket) assembly
2. Detachment grooves
3. Neck assembly
4. Neck attachment cavity
123
4