Remington mb4560 User manual

MB4560
Touch Control Lithium Beard
Trimmer

2
Thank you for buying your new Remington® product. Please read these
instructions carefully and keep them safe. Remove all packaging before use.
F IMPORTANT SAFEGUARDS
WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE, OR
INJURY TO PERSONS:
1 This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been supervised/instructed and
understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be done by children unless they are
older than 8 and supervised. Keep the appliance and cable out of reach of
children under 8 years.
2 An appliance should never be left unattended when plugged into a power
outlet, except when charging.
3 Do not immerse the appliance in liquid; do not use it near water
in a bath-tub, basin or other vessel; and don’t use it outdoors.
4 Do not use this product if it is not working correctly, if it has been
dropped or damaged, or dropped in water.
5 Make sure the power plug and cord do not get wet.
6 Do not plug or unplug the appliance with wet hands.
7 Do not use the product with a damaged cord. A replacement can be obtained
via our International Service Centres.
8 Store the product at a temperature between 15°C and 35°C.
9 Do not use attachments other than those we supply.
10 This appliance is not intended for commercial or salon use.
11 Keep the appliance dry.
ENGLISH

3
CKEY FEATURES
1 3 position slide switch (O/On/Lock motor on)
2 Cutting length controls
3 Digital display for:
- Battery level
- Length setting, mm
- Lock / unlock
- Speed level
4 Motorised comb
5 Mode button
6 Tri Boost System
7 Micro USB port
8 USB cable
9 Adaptor
10 Storage Pouch
ENGLISH
GBDNLFEIDKSFINPSKCZ
HUN
PLRUTRROGRSL
AE HR
UA
6
5
7
2
3
4
1
8 9
10

4
CGETTING STARTED
• Beforetheunitcanbeusedforthersttime,keephandsawayfromtouch
screen area and pull out the plastic tab marked with an arrow from the
bottom of the unit. The plastic tab is only for shipping and can be discarded.
,CHARGING YOUR APPLIANCE
• Beforeusingyourhairclipperforthersttime,chargefor90minutes.
• Ensuretheproductisswitchedo.
• Connectthechargingadaptortotheproductandthentothemains.The
charging indicator will illuminate. When fully charged, the display screen turns
o.
• Yourtrimmercannotbeovercharged.However,iftheproductisnotgoingto
be used for an extended period of time (2-3 months), unplug it from the mains
and store.
• Fullyrechargeyourappliancewhenyouwouldliketouseitagain.
• Topreservethelifeofyourbatteries,letthemrunoutevery6monthsthen
recharge for 90 minutes.
,CHARGING VIA STANDARD ELECTRICAL SOCKET
• Ensuretheproductisswitchedo.
• Connectthechargingadaptortotheproductandthentothemains.
• Whenchargingthedigitaldisplaywillilluminate.
• Allow90minutesforacompletecharge.
• Thisapplianceshouldbechargedbyapprovedsafetyisolatingadaptors
PA-0510E (for EU version) or PA-0510U (for UK version) with the output
capacity of 5.0V dc; 1A;
,USB CHARGING VIA PC
• Ensuretheproductisswitchedo.
• ConnectyourUSBcabletotheUSBportonthePC.
• ConnecttheUSBcabletoyourbeardtrimmer.
• Whenchargingthedigitaldisplaywillilluminate.
• Allow90minutesforacompletecharge.
,CORDED USE
• Connectthechargingadaptortotheproductthentothemains.
• Whenthecordisconnectedtothemains,adigitaldisplaywillbedisplayedon
the appliance.
ENGLISH

5
,CAUTION
• Extendedmainsonlyusewillresultinthereductionofthebatterylife.
,WARNING
• TheappliancecannotbeoperatedincordedmodewhileconnectedtoaPC
via the USB port.
,CORDLESS USE
• Whentheunitisswitchedonandfullycharged,theproductcanbeusedin
cordless mode for 50 minutes.
F INSTRUCTIONS FOR USE
• Alwayscombyourbeardormoustachewithanecombbeforeyoustart
trimming.
• Turntheproductonbyslidingthe3positionslideswitchdowntothe
middle position. This will turn the LCD display on and enable height
adjustments and boost adjustments to be made.
• Yourtrimmercanbeadjustedineither0.1mmor0.5mmincrements.To
switch between these, press and hold the mode button for 3 seconds. The
increment that the trimmer is now set at will be displayed (or ash) for 1
second.
,USING THE TOUCH SCREEN
• Thetrimmercombcanbeadjustedtogiveyou175dierenttrimlengths,
with 0.1mm increments, simply by pressing the arrows on the touch
screen. Press and hold the arrow up to increase the cutting length and down
to decrease it. The setting number will appear on the digital display.
• Selectthedesiredboostlevelbypressingtheboostbuttonwiththe3
position slide switch in the middle position. The display will indicate the
level.
• Oncethedesiredlengthandboostlevelhavebeenselectedslidethe3
position slide switch to the last position (the furthest down) to lock the
cutting length and turn the motor on.
• Note:Adjustmentstolengthandboostcanbedoneanytimethe3position
slide switch is set to the middle position. Adjust the cutting length and or
boost level by pressing the arrows or boost button on the touch screen.
• Pleasenotethatthemotorwillonlyrunwhenthe3positionslideswitchis
set to lock, the last position (furthest down). This is to ensure the cutting
length does not adjust whilst you are cutting your hair.
• Note:Trimmercombmustbeattachedtothegroomerinordertousethe
hair length selector. To achieve 0.4mm, the comb must be removed.
ENGLISH
GBDNLFEIDKSFINPSKCZ
HUN
PLRUTRROGRSL
AE HR
UA