5
ENGLISH
• To remove, slide the attachment forwards with your thumb. The foil shaver has a
release button which must be pressed before it can be slid o.
• To t, slide the attachment onto the body until it clicks into place.
FITTING AND REMOVING FIXED GUIDE COMBS FIG. B
To Fit
• Hook the front of the guide comb over the teeth of the T-blade.
• Press the back of the guide comb down until it clicks into place.
To Remove
• Lift the tab on the back of the guide comb upwards until it comes free from the
T-blade.
ADJUSTABLE STUBBLE COMB
• Fit the adjustable stubble comb in the same way as you would t a xed guide comb.
• The 1.5 - 5 mm comb can be adjusted by turning the wheel to the desired setting. Turn
the wheel clockwise for longer length and anticlockwise for shorter length.
• The indicator on the wheel will point to the chosen setting.
• Use the trimmer without the adjustable comb for trimming hair close to the skin. This
will trim hair to 1.0 mm, holding the blades perpendicular to the skin will trim hair to
0.5 mm.
INSTRUCTIONS FOR USE
• Comb facial hair with a ne comb before you start trimming.
• Comb your hair in the direction that it grows so that the hairs are at their maximum
height and facing in the same direction.
• After trimming, lightly go over the trimmed areas with the foil to get a smooth clean
nish.
• Since all hairs do not grow in the same direction, you may want to try dierent
trimming positions (i.e. upwards, downwards or across) for better results.
• Hair should be dry and free from any waxes or lotions.
• If hair builds up during use, switch the unit o, remove any attachment in use and
clean any excess hair clippings from the attachment and groomer.
TO THIN AND TAPER THE BEARD/MOUSTACHE
• Attach the adjustable stubble comb or a xed guide comb to the T-blade. If you are
trimming for the rst time start with the maximum trimming length setting.
• Turn the unit on.
• Start trimming under the chin following the line of the jaw.
• Place the at top of the trimmer comb against the skin.
• Slowly slide through the hair. Work upwards towards the ear and upper beard line.
Repeat from dierent directions as necessary.
• Tidy the beard edges using the T-blade. Use slow controlled movements to create
contoured lines.
GB
DE
NL
FR
ES
IT
DK
SE
FI
NO
PT
SK
CZ
PL
HU
RU
TR
RO
GR
SI
HR
SR
UA
BG
AE
