Remington Omniblade Multi-Pro User manual

I remington-europe.com
Register online for an EXTRA year guarantee
Visit uk.remington-europe.com/product-registration You must register within 28 days of purchase.
Omniblade Multi-Pro
HG5000

2
g
e
f
m
n
i
j
l
1
23
k
h
A

3
h
C
3 mm
6 mm
9 mm
CLICK!
h
E
CLICK!
h
D
h
F
h
B

4
Thank you for buying your new Remington® product. Please read these instructions carefully
and keep them safe. Remove all packaging before use.
IMPORTANT SAFEGUARDS
• This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been supervised/instructed and
understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be done by children unless they are
older than 8 and supervised. Keep the appliance and cable out of reach of
children under 8 years.
E Suitable for use in a bath or shower.
• Do not use the product with a damaged cord.
• The battery in this device is not replaceable.
• Do not use the appliance if it is damaged or malfunctions.
• Do not use attachments other than those we supply.
• This appliance should never be left unattended when plugged into a power outlet,
except when charging.
• Keep the power plug and cord away from heated surfaces.
• Do not plug or unplug the appliance with wet hands.
• Do not twist or kink the cable, or wrap it round the appliance.
• This appliance is not intended for commercial or salon use.
PARTS
1. On/O switch
2. Charging indicator light
3. Charging connector
4. Adjustable precision comb
5. Fixed guide combs (7, 9, 12, 16mm)
6. Micro trimmer
7. Facial cleansing brush attachment
8. Body blade attachment
9. Body blade comb
Not shown:
• USB charging cable
• Travel pouch

5
CHARGING YOUR APPLIANCE
It is recommended to fully charge your appliance before using it for the rst time.
1. Ensure the product is switched o.
2. Connect the product to the USB cable and then to the USB end of the cable to a powered
USB port.
CHARGING INDICATOR LIGHTS
Charging Fully charged Battery Low
5 min
The lights will come in a
repeating sequence from
bottom to top while
charging.
All lights will stay on for 5
minutes then go out.
The bottom light will ash
for 5 seconds.
Light o Light on Light ashing
• Your trimmer cannot be overcharged. However, if it is not going to be used for an
extended period of time (2-3 months), unplug it from the mains supply.
• To preserve the life of your batteries, let them run out every 6 months then recharge for 2
hours.
• Run time from fully charged is up to 60 mins.
ATTACHMENTS
TO FIT AND REMOVE ATTACHMENTS (FIG. B)
Ensure that the device is switched o before tting or removing attachments.
• To remove, rotate the attachment anti-clockwise until it unlocks and then lift it o.
• To t, place the desired attachment on top of the device and rotate the attachment
clockwise to lock it into place.
GB
AE

6
FITTING AND REMOVING FIXED GUIDE COMBS (FIG. C)
To Fit
• Hook the front of the guide comb over the blade.
• Press the back of the guide comb down until it clicks into place.
To Remove
• Lift the tab on the back of the guide comb upwards until it comes free from the blade.
FITTING AND REMOVING THE ADJUSTABLE PRECISION COMB (FIG. D)
• Clip the adjustable comb over the blade as shown ensuring that the three tabs on the
comb t into the notches on the back of the blade (shown by the smarks).
• The 0.5 - 5 mm comb can be adjusted in 0.5mm increments simply by turning the wheel
until the desired setting is shown on the scale. Turn the wheel clockwise for longer length
and anticlockwise for shorter length.
• To remove, lift the back of the comb upwards and lift it o the blade.
INSTRUCTIONS FOR USE
Switch the product on by rotating the on-o switch to the I mark.
Always comb your beard or moustache with a ne comb before you start trimming.
TO TRIM THE BEARD
1. Select your desired trimming length comb. If you are trimming for the rst time start with
the maximum trimming length setting.
2. Turn the unit on.
3. Place the at top of the comb against the skin.
4. Slowly slide through the hair. Repeat from dierent directions as necessary.
5. If hair builds up in the trimmer comb during the trimming process, switch the unit o, pull
o the comb and brush the hair o.
TO GET A SHAVEN LOOK
To trim any length of beard or stubble hair for a clean, shaven look then follow the above steps
without a comb attached to the blade head.
Place the at top of the blade against the skin and slowly slide through the hair against the
direction of growth.
Shave in an upwards direction when shaving under the chin (Fig. A).
TRIMMING AND EDGING
1. Hold the device with the back side of the blade facing you with no combs attached.
2. Start with the blades resting lightly against your skin, use motions towards edge of beard
line to trim to desired locations in facial area.
3. Shape as desired.

7
TRIMMING WITH SHAVING GEL
Follow the same instructions as dry shaving if using shaving gel.
Caution: After use with shaving gel, please rinse the blade under warm water to clean away
any excess gel and debris.
BODY HAIR MAINTENANCE
Attachments
Body blade attachment
Body hair maintenance: Trimming to length
1. Fit the body blade attachment.
2. Body hair can be trimmed to 3 dierent lengths (3, 6 and 9 mm). Select the desired length
by sliding the comb into one of the three slots on the side of the attachment (Fig. E).
3. Place the at side of the attachment against the skin.
4. Slowly slide the trimmer through the hair in the direction of hair growth.
5. Use slow, well-controlled movements.
Body hair maintenance: Removal
1. Remove the comb from the body blade attachment and go over the areas where you want
to remove the body hair.
2. Stretch the skin with your free hand to make the hairs stand upright.
3. Use light pressure and shave against the direction of hair growth.
DETAILED NOSE, EYEBROW AND EAR HAIR TRIMMING
Attachments
Micro trimmer
Nose and ear:
1. Fit the micro trimmer.
2. Insert the attachment gently into the nostril or ear.
3. Gently move the attachment in and out while rotating the body of the groomer at the
same time.
• Don’t insert the attachment more than 6 mm.
• Wash the attachment after each use.
Eyebrow:
1. Slide the desired eyebrow comb attachment (3 or 6 mm) over the trimmer head (Fig. E).
2. Carefully guide the attachment to remove any stray or longer hairs from the eyebrow.
3. To completely remove hairs, let the attachment touch the skin then move over the desired
area.
GB
AE

8
FACIAL CLEANSING BRUSH
Attachments
Facial Cleansing Brush
1. Moisten the brush bristles by running under water. NOTE: DO NOT use the brush head
whilst completely dry as this can cause skin irritation.
2. Dampen your skin with water and apply face wash onto your skin. Alternatively, apply
your face wash directly onto the brush.
3. We recommend cleansing with the Facial Cleansing brush in 3 sections:
• T-Zone (1), Right side (2) and Left side (3).
4. Switch on using the On/O button.
5. Place the facial brush directly onto your skin.
6. Gently glide the brush over the skin and beard in circular motions avoiding the delicate
eye area.
NOTE: Try to avoid applying too much pressure with the brush when directly on the skin.
CARE FOR YOUR GROOMER
Care for your product to ensure a long lasting performance. We recommend that you clean
your groomer after each use.
AFTER EACH USE
• Brush any accumulated hairs from the groomer and attachment heads.
• The easiest and most hygienic way to clean the groomer is by detaching the head from
the groomer body and rinsing the head with warm water.
• Place one or two drops of cutter oil or sewing machine oil on the blades.
• Turn the device on to distribute the oil evenly, wipe o any excess oil.
BATTERY REMOVAL
We strongly recommend that a professional removes the rechargeable battery. Parts of
the shaver case, and tools have sharp edges and may cause injury if not handled correctly.
• The rechargeable battery must be removed from the appliance before it is scrapped.
1. Ensure the device is discharged of all power. To do this, switch it on and allow it to run
until it stops.
2. Remove any attachments.
3. Pry o the switch button/switch cover.
4. Unscrew the 2 screws under the cover then remove the lower housing.
5. Slide out the battery assembly.
6. Unscrew the 2 screws from the cover then remove the battery.

9
• Used batteries must be removed from the appliance and disposed of at an appropriate
ocial recycling/collection point.
• Do not attempt to operate the device once you have opened it.
RECYCLING
WTo avoid environmental and health problems due to hazardous
substances, appliances and rechargeable and non-rechargeable
batteries marked with one of these symbols must not be disposed of
with unsorted municipal waste. Always dispose of electrical and
electronic products and, where applicable, rechargeable and
non-rechargeable batteries, at an appropriate ocial recycling/
collection point.
SERVICE AND GUARANTEE
Defects aecting product functionality appearing within the guarantee
period will be corrected by replacement or repair at our option provided
the product is used and maintained in accordance with the instructions.
Your statutory rights are not aected.
This warranty shall not be valid where it is contrary to U.S. and other
applicable laws, or where the warranty would be prohibited under any
economic sanctions, export control laws, embargos, or other restrictive trade measures
enforced by the United States or other applicable jurisdictions. This includes, without
limitation, any warranty claims implicating parties from, or otherwise located in, Cuba, Iran,
North Korea, Syria and the Crimea region.
To claim an extra 1 year guarantee, register your product online within 28 days of purchase.
Register at: https://uk.remington-europe.com/product-registration
Consumables are guaranteed only for their recommended lifecycle. Replacement/spare parts*
are excluded and are only covered by a 1 year warranty.
*Examples include, but are not limited to, adaptors, haircare attachments, grooming accessories, etc.
$
GB
AE

10
SERVICE CENTRE
UNITED KINGDOM
G 0800 212 438 (free call mainland UK)
Spectrum Brands (UK) Ltd
Fir Street, Failsworth, Manchester
M35 0HS, UK
www.remington.co.uk
productsuppor[email protected]o.uk
IRELAND
G 142 951 40
Remington Consumer Products,
Unit B12, Ballymount Corporate Park,
Ballymount, Dublin 12
https://ie.remington-europe.com
productsuppor[email protected]o.uk