Remington TITANIUM COMFORT PRO User manual

2 YEAR WARRANTY
To register your product go to:
www.remington-products.com.au
www.remington.co.nz
PF7500AU
USE & CARE
MANUAL
PLEASE READ
PRIOR TO USE
TITANIUM COMFORT
PRO

2
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic precautions should
always be observed, including the following.
READ ALL INSTRUCTIONS BEFORE USING
For additional protection, the installation of a residual current
device (rcd) having a rated residual operating current not
exceeding 30 mA is advisable in the electrical circuit supplying
the bathroom. Ask your installer for advice.
WARNING: TO REDUCE THE RISK OF BURNS, ELECTROCUTION
AND FIRE OR INJURY TO PERSONS
DANGER: As with most electrical appliances, electrical parts are
electrically live even when the switch is off.
• The appliance should never be left unattended when plugged into
a power outlet, except when charging the appliance.
• This appliance should not be used by children or other persons
with reduced physical, sensory or mental capabilities or lack
of experience and knowledge unless they have been given
supervision or instruction concerning use of the appliance in a safe
way and understand the hazards involved. Children shall not play
with the appliance. Cleaning and user maintenance shall not be
made by children without supervision.
• Never operate this appliance if it has a damaged cord or plug,
if it is not working correctly, if it has been dropped or damaged,
or dropped into water. If the supply cord or plug of the appliance
is damaged it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard. It
cannot be repaired. Keep the cord away from heated surfaces.
• Charge, use and store the product at a temperature between 0°C
and 32°C.
• Do not use outdoors or where aerosol (spray) products are being
used, or where oxygen is being administered.
• Do not use this appliance with damaged or broken tracks, foils or
cutters, as injury may occur.

3
• For use on facial hair only. Not intended for shaving the hair on
your head.
• Do not plug or unplug the appliance with wet hands.
• For household use only.
• Do not place or store the appliance or charging adaptor where it
can fall or be knocked into a sink or bath.
• Do not place in or drop into water or any other liquid for extended
periods of time.
• If an appliance falls into water, “unplug it” immediately. Do not
reach into the water.
• Unplug the charging adaptor from the electrical outlet immediately
after fully charging.
• Unplug and switch off this appliance before cleaning it.
• Use this appliance only for its intended use as described in this
manual.
• Do not use attachments not recommended by Remington.
• Never drop or insert any object into any opening of this appliance.
• Always store the charging adaptor in a moisture-free location.
• Do not use on people who are asleep.
• Do not use an extension cord or a voltage converter with this
appliance.
• Do not wrap the cord around the appliance.
Remington strongly recommends that an approved Safety Switch
(Residual current device) be installed to protect all bathroom power
outlets. Ask an electrical contractor for advice.
SAVE THESE INSTRUCTIONS

4
PF7500AU TITANIUM COMFORT PRO
USE & CARE INSTRUCTION MANUAL
Thank you for purchasing your new Remington®Titanium Comfort Pro.
Inside this manual you will find tips on using and caring for your shaver.
KEY PARTS
1. On/Off button
2. Foils
3. Cutter assembly
4. Intercept trimmer
5. Hair pocket
6. Pop up trimmer (not shown)
7. Charging pins (not shown)
Also Includes
• Head guard
• Power adaptor
• Cleaning brush
• Storage pouch
6
3
7
1
4
2
5

5
PF7500AU SPECIFICATIONS
Power System Lithium Rechargeable
Full Charge Time 2 hours
Cordless Shave Time 50 minutes
Quick Charge Yes
Indicators Charging/Low Battery
Voltage Type Worldwide
Replacement Part SPF-PFAU
Water Resistance Washable Head
CHARGING
NOTE: BEFORE USING, READ THE IMPORTANT SAFETY INSTRUCTIONS IN
FRONT OF THE MANUAL.
1. Connect the cord to the shaver and then to the electrical outlet
(Diagrams A & B). The charging indicator light will glow green.
2. Your shaver will have a partially charged battery. We recommend that you charge
the battery for the full charge time prior to the first use.
3. Charge shaver to a full charge before its first use.
4. Use shaver until recharge is required.
Quick Charge
A 5 minute quick charge will allow for 3 minutes of shaving.
CAUTION!
• Make sure the shaver and your hands are dry when charging the shaver.
• Always charge the shaver in a cool, dry place.
A
B

6
SHAVING
1. Press power button to turn on. (Diagram C)
2. Stretch the skin with your free hand so the hairs stand upright.
3. Hold the shaving head so the foils and intercept trimmer touch your skin
simultaneously. Apply light pressure while shaving and use linear strokes.
(Diagram D)
SHAVING TIPS (DRY)
• Ensure your skin is free of oils.
• Wait at least 15 minutes after getting up before shaving, to ensure your face is
free of puffiness that may be present from sleeping.
• Hold the shaver 90° to your skin.
• Stretch your skin and shave against the direction of your beard growth using linear
strokes.
• For areas such as the chin and neck where hair grows in different directions use
small circular strokes.
• While shaving do not press hard against the skin to avoid skin irritation and/or
damage to the foils.
**We recommend that you use your new shaver daily for up to four
weeks to allow time for your hair and skin to become accustomed to the
new shaving system**
C
D

7
CLEANING & MAINTENANCE
The shaver is a washable appliance. The head assembly part may be cleaned
under water.
NOTE: **When cleaning your shaver, make sure the shaver is turned off and
disconnected from the power cord.**
CAUTION!
• To clean the external surfaces of the shaver, use a damp cloth. Do not use strong
detergents or other chemicals.
• To dry, wipe the surface of the shaver with a dry towel. Do not use a hair dryer or
heater to dry the shaver.
NOTE: Lubricate cutters after rinsing.
DAILY CLEANING
NOTE: We recommend following these steps after each use.
1. Grasp the front and back of the cutter assembly and pull away from the shaver
body. (Diagram E)
2. Tap out excess hair shavings and use the cleaning brush to sweep any loose hairs
away. (Diagrams F-G)
3. Rinse the head of the assembly under running water. Gently towel dry or leave to
air dry.
4. Replace the head assembly when dry by placing the assembly on top of the hair
pocket, press down and click into place. (Diagram H)
NOTE: Lubricate teeth of trimmer with oil every six months.
E
F
G
H

Article Price each
AUD
Price each
NZD Qty Amount
$
Face Saver: Pre-shave Powder Stick
SP4 SP5 $11.95 AUD $14.95 NZD $
$ $ $ $
Sub Total
Postage &
handling
TOTAL
7.50
R
Shaver Saver: Aerosol Spray Cleaner
eplacement
Shaving Heads & Cutters for PF7500AU
SPF-PFAU
$11.95 AUD $39.95 AUD
$14.95 NZD $44.95 NZD
Remington is a Registered Trademark of Spectrum Brands, Inc., or one of its subsidiaries.
Spectrum Brands Australia Pty Ltd Locked Bag 3004 Braeside, VIC 3195 AUSTRALIA

MONTHLY CLEANING
1. Perform steps 1-3 of the daily cleaning.
2. Place a drop of soap on each cutter and hairpocket. (Diagram I)
3. Brush the soap around vigorously with the cleaning brush. (Diagram J)
4. Add a small amount of water to the cutters.
5. Replace the foil assembly. (Diagram K)
6. Turn the shaver on for approximately 30 seconds.
7. While shaver is running rinse the foils under running water. (Diagram L)
8. Turn off shaver, remove foil assembly and rinse the cutters, hair pocket and foil
assembly throughly. (Diagram M)
9. Shake off excess water.
10. Replace foil assembly.
11. Allow shaver to dry before next use.
10
I
J
K
L
L
M