Remington Style Series User manual

Style Series Foil Shaver
I www.remington.co.uk
F5
Register online for an EXTRA year guarantee
Visit www.remington.co.uk/productregister. You must register within 28 days of purchase.

e
f
m
k
m
g
i
l
j
n
o r s

E
F
G
A B
CD

4
Thank you for buying your new Remington® product. Please read these instructions
carefully and keep them safe. Remove all packaging before use.
IMPORTANT SAFEGUARDS
• This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been supervised/instructed and
understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be done by children unless they are
older than 8 and supervised. Keep the appliance and cable out of reach of
children under 8 years.
• Always check the appliance before you use it. Do not use the appliance if it is
damaged, as this may cause injury.
• The adaptor contains a transformer. Do not cut off the adaptor to replace it
with another plug, as this causes a hazardous situation.
E Suitable for use in a bath or shower.
• WARNING: Detach the shaver from the charging adapter before cleaning it in
water.
• Do not use the product with a damaged cord. A replacement can be obtained
via our International Service Centres.
• WARNING: For recharging the battery, only use the charger supplied with the
appliance - type reference PA-0510K (UK).
• Always replace a damaged adaptor with one of the original type.
• Do not use the appliance if it is damaged or malfunctions.
• This appliance should never be left unattended when plugged into a power outlet,
except when charging.
• Keep the power plug and cord away from heated surfaces.
• Do not plug or unplug the appliance with wet hands.
• Do not twist or kink the cable, or wrap it round the appliance.
• This appliance is not intended for commercial or salon use.

5
PARTS
1. On/o switch
2. Foil screens
3. Cutter assembly
4. Charging indicator lights
5. Hairpocket
6. Power port
7. Pop-up trimmer
8. Head release buttons
9. Head lock button
10. Stubble head guard
11. Beard trimmer attachment
12. Guide combs (x 6)
Not shown:
13. Adaptor
14. Cleaning brush
GETTING STARTED
CHARGING YOUR APPLIANCE
• It is recommended to fully charge your appliance before using it for the rst time.
• Ensure the product is switched o.
• The adaptor automatically adjusts to a main voltage between 100V and 240V.
• Connect the shaver to the adaptor and then to the mains.
CHARGING INDICATOR LIGHTS
Charge Level Lights
Charging The lights will come on one after the other then go o in a
repeating pattern.
Fully Charged Both lights will come on for 5 minutes then go out.
Low charge/charging
required The bottom light will ash rapidly.
Battery capacity 50%
or higher Both lights will come on.
Battery capacity 50%
or lower The bottom light will come on.
• Run time from fully charged is up to 50 mins.
• Charge time from empty is 2 hours.
• Note: To preserve the life of your batteries, let them run out every 6 months then fully
charge.

6
INSTRUCTIONS FOR USE
It is recommended that you use your new shaver daily for up to two weeks to allow time for
your beard and skin to become accustomed to the new shaving system.
• Make sure your shaver is properly charged.
• Switch the shaver on by pressing the on/o switch.
SHAVING
• Stretch the skin with your free hand so the hairs stand upright.
• Hold the shaving head so that the foils touch your face.
• Use short linear strokes.
TRIMMING
• Slide up the trimmer release button to activate the trimmer.
• Hold the trimmer at a right angle to your skin.
• To retract the trimmer, push the top rear of the trimmer down until it locks under the
trimmer release button.
STUBBLE LOOK
Fit the stubble head guard to your shaver for a 3-day stubble look.
HEAD LOCK
Normally, the head pivots freely but its movement can be restricted by sliding the head lock
button to the locked Lposition.
BEARD TRIMMER ATTACHMENT
Use the beard trimmer without a comb tted to trim hair close to the skin. This will trim hair
to 1 mm. Holding the blades at right angles to the skin will trim hair to 1.5 mm.
To attach a comb to the beard trimmer
1. Press the two head release buttons and remove the foil head (Fig A).
2. Fit the beard trimmer (Fig B).
3. Hook the front edge of the selected guide comb over the beard trimmer blade (Fig C).
4. Press the comb downwards until it clicks into place (Fig D).
TIPS FOR BEST RESULTS
• Always hold the shaver at right angles to the skin so that all foils are touching the skin
with equal pressure.
• Use moderate to slow stroking movements. The use of short linear motions in
stubborn areas may obtain a closer shave, especially along the neck and chin line.
• DO NOT press hard against the skin in order to avoid irritation and damage to the foil
heads.

7
CLEANING AND MAINTENANCE
• To ensure long lasting performance clean after each use.
• Ensure the appliance is switched o and unplugged from the mains.
• The easiest and most hygienic way to clean the appliance is by rinsing the appliance
head after use with warm water.
DRY CLEANING
• Press the head release buttons and and pull the head upwards (Fig E).
• Gently tap out the excess hair shavings and use a cleaning brush to clean out the hair
pocket if necessary (Fig F).
• Note: Do not use a brush to clean the shaving foils.
• Replace the head assembly.
WASHABLE CLEANING
• Press the head release buttons and and pull the head upwards (Fig E).
• Do not use the brush to clean the foils but blow the shavings out or rinse in running
water (Fig G).
• Use the cleaning brush to sweep any loose hairs from the cutter and trimmer. Rinse in
running water.
• Replace the head assembly.
• Lubricate the teeth of the trimmer every six weeks with a drop of sewing machine oil.
REPLACING THE FOILS AND CUTTERS
• To ensure continued high quality performance from your shaver, we recommend the
foils and cutters are replaced regularly.
Signs that your foil/s and cutter/s need replacing:
• Irritation: as foils get worn, you may experience skin irritation.
• Pulling: as the cutters wear, your shave may not feel as close and you may feel the
cutter pulling your hair.
• Wear through: you may notice that the cutters have worn through the foils.
TO REPLACE THE FOIL/CUTTERS
• Press the head release buttons and and pull the head upwards.
• Fit the new head assembly over the hair pocket and press down to click into place.

8
BATTERY REMOVAL
• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when removing
the battery.
1. Pry o the two decorative side panels.
2. Unscrew one screw from the bottom of the shaver and remove the bottom panel.
3. Remove the foil assembly and unscrew the 4 screws underneath it.
4. Remove the two E-rings one on each side of the head then lift o the upper head
assembly.
5. Unscrew the 2 screws below the upper head assemly then lift the rest of the head o
the body.
6. Pry o the upper decorative panel to expose 2 screws. Remove the screws.
7. Remove the front panel to expose 4 screws. Remove the 4 screws then remove the
back housing.
8. Lift out the battery and printed circuit board assembly.
9. Disconnect he battery from the circuit board.
10. Dispose of the battery safely.
RECYCLING
WTo avoid environmental and health problems due to hazardous
substances, appliances and rechargeable and non-rechargeable
batteries marked with one of these symbols must not be disposed of
with unsorted municipal waste. Always dispose of electrical and
electronic products and, where applicable, rechargeable and
non-rechargeable batteries, at an appropriate ocial recycling/
collection point.

9
SERVICE AND GUARANTEE
Defects aecting product functionality appearing within the guarantee
period will be corrected by replacement or repair at our option
provided the product is used and maintained in accordance with the
instructions. Your statutory rights are not aected.
To claim an extra 1 year guarantee, register your product online within 28
days of purchase.
Register at: www.remington.co.uk/productregister
Consumables are guaranteed only for their recommended lifecycle. Replacement/spare
parts* are excluded and are only covered by a 1 year warranty.
*Examples include, but are not limited to, adaptors, haircare attachments, grooming accessories, etc.

10
SERVICE CENTRE
UNITED KINGDOM
G Tel [phone] (free call mainland UK)
Spectrum Brands (UK) Ltd
Fir Street, Failsworth, Manchester
M35 0HS, UK
www.remington.co.uk
IRELAND
G Tel [phone]
Remington Consumer Products,
Unit B12, Ballymount Corporate Park,
Ballymount, Dublin 12
www.ie.remington-europe.com
I REGISTER ONLINE
Register online for an EXTRA year guarantee*.
Visit www.remington.co.uk/productregister
*You must register within 28 days of purchase.