Remington MPT3400AU Installation guide

MPT3400AU SMOOTH & SILKY® BEAUTY TRIMMER
USE & CARE INSTRUCTION MANUAL
Thank you for purchasing your new Remington® Smooth & Silky®
Beauty Trimmer. This trimmer comes with two trimming blades. The
larger blade can be used for trimming body hair, neck and sideburns. The
smaller blade is ideal for detailing nose/ear hair and eyebrow trimming.
Included with your Smooth & Silky® Beauty Trimmer is a comb guide
with 2 length settings for short or long trim lengths.
KEY PARTS
On/Off switch
Protective cap
Angled head
Trimmer
Comb guide
Fine detail
trimmer

GETTING STARTED - INSERTING THE BATTERY
1. Make sure the trimmer is “OFF” and remove the protective cap.
2. Hold the upper part of the unit and gently slide the lower part off.
(Figure A)
3. Insert one “AAA” ALKALINE battery positive end down. (Figure B)
4. Slide bottom part back onto the unit, making sure the notch slides
over the ON/OFF switch. (Figure C)
BATTERY CAUTIONS:
s 5SEOFNONALKALINEBATTERIESWILLIMPAIRTHEUNITSOPERATING
performance.
s "ATTERIESSHOULDNOTBELEFTINTHEUNITIFTHEUNITISNOTINUSEFOR
long periods.
s 4OPREVENTBATTERYCORROSIONTHEUNITSHOULDBESTOREDINADRY
environment.
s $EADBATTERIESSHOULDBEREMOVEDIMMEDIATELYANDDISPOSEDOF
properly.
s $ONOTUSERECHARGEABLEBATTERIESWITHTHISPRODUCT4HELOWER
voltage in rechargeable batteries impairs the performance of the
cutting unit.

HOW TO USE YOUR SMOOTH & SILKY® BEAUTY TRIMMER
Before use:
Test a small area on an arm or leg before using your trimmer completely.
Discontinue use immediately if any sensitivity or allergic reaction occurs.
Do not use on sensitive or irritated skin.
How to Use:
This trimmer comes with two trimming blades:
The larger blade can be used for trimming body hair, neck and
sideburns.
The smaller blade is ideal for detailing nose/ear hair and eyebrow
trimming. It also comes with an attachment comb that helps you to
achieve an even cut when you do not want to completely remove the hair.
The attachment comb has two sides, the long tooth side leaves hair
longer than the short tooth (we recommend starting with the long tooth).
To use the attachment comb, be sure the unit is in the “off” position and
slide it over the trimming blades. (Figure D) Make sure that the teeth of
the comb are facing in the same direction as the trimming blade and that
the top of the comb is even with the top of the trimmer. If you want to
completely remove hair, use the trimmer without the attachment comb.
To operate the trimmer, slide the “on” switch towards the trimming
blades. When you are finished trimming, slide the “on” switch away from
the blades.

USEFUL TRIMMING TIPS
1. Place the trimmer at a slight angle to the skin, and trim in the
direction of hair growth.
2. Continue trimming in the direction of growth. Be careful not to
apply excess pressure to the blade as this may damage the blade,
and can result in injury to the skin during trimming.
3. Pull the skin taut with one hand during the trimming process to
ensure the closest possible cut.
CLEANING & MAINTENTANCE
Note: This product does not contain any user-serviceable parts. To ensure
that you get optimal performance from it, follow these simple cleaning
and lubrication tips:
CLEANING YOUR TRIMMER
After each use, brush or blow accumulated hair from the cutting unit.
CLEANING INSIDE THE HANDLE
For a more thorough cleaning, remove hairs from inside the handle.
1. Make sure the trimmer is OFF and push down the lock to release
the trimmer head. (Figure E)
2. Remove trimmer head and clean both head and handle tip with
brush.
3. Apply a drop of mineral oil or baby oil to the top of the cutting
blades.
4. Replace trimmer head and snap into place by pushing the lock
back up.