Remington IPL6000 i-Light Pro User manual

IPL6000
Use and
Care Guide
Register Your New Product Today!
By registering your new Remington®product, you will receive these important benefits:
Proof of Ownership • Product Protection • Product Registration • Special Offers
Register online at: www.RemingtonProducts.com

Contents
PAGE
4 Introduction
5 How Does the i-Light Pro IPL System work?
6 i-Light Pro System Diagram Reference
7 Getting to Know Your i-Light Pro System
8 QUICK REFERENCE GUIDE
10 What is the Intended Use for i-Light Pro IPL System? (Indications)
12 Contraindications
13 WARNINGS
16 Benefits and Risks
18 What to Expect with i-Light Pro IPL System
20 How to Use Your i-Light Pro IPL System
20 Set-up
21 Each Time You Use i-Light Pro IPL System
21 Between Treatments

Contents
PAGE
22 Using i-Light Pro IPL System for the First Time
22 Testing on a patch of skin
23 Using i-Light Pro IPL System Every Time
23 Getting Ready to Use
23 Unlocking the i-Light Pro IPL system using the Skin Tone Sensor
26 Setting the ENERGY LEVEL
28 Begin Treatment
31 After Use
32 Getting the Best Results
32 Taking Care of Your i-Light Pro IPL System
32 Cleaning
32 Replacing the Disposable Cartridge
36 Disposing of Your i-Light Pro IPL system
36 Troubleshooting
42 Performance Guarantee
44 Contact Information

4
Introduction
Congratulations on the purchase of your
new i-Light™ Pro Intense Pulsed Light
(IPL) Hair Removal system! You’re on
your way to being liberated from the daily
chore of hair removal.
The i-Light Pro IPL system is a revolution-
ary light-based device designed for the
removal of unwanted body hair at home.
It uses the same Intense Pulsed Light
(IPL) technology that professional derma-
tologists and salons use, but is optimized
for use in the privacy and comfort of your
own home.
Unlike most at-home hair removal meth-
ods, the i-Light Pro IPL system doesn’t cut
or pull out hair—it actually works below
the skin’s surface to disable active hairs
and helps prevent new ones from grow-
ing. This is a gradual process. You’ll start
to see results within two weeks after your
initial treatment and results will improve
gradually over time.

5
How does the i-Light Pro IPL System Work?
The process of light-based hair removal is
well-known and has been clinically prov-
en around the world for over 15 years.
The i-Light Pro system uses this same
proven technology to emit an intense
pulse of light (IPL) to heat up and dis-
able active hair follicles. The light energy
targets dark coloring in body hair, which
is why it works best on lighter skin tones
and naturally dark hair. To determine if
your skin and hair color are ok to use with
the i-Light Pro IPL system, refer to infor-
mation provided on page 10 and 11.
Every hair in our body goes through a
continuous growth cycle, from active to
resting phases. The time it takes to com-
plete a full hair growth cycle varies, but
is typically 18-24 months. Light-based
treatments only affect hairs in the active
phase, which can account for up to 90%
of hair follicles. That’s why we recom-
mend using the i-Light Pro system three
times in the first month to ensure you hit
every active hair. After that, use the i-Light
Pro system as needed for any missed
hairs or hairs that have recently become
active.
• The first 3 sessions with the i-Light Pro
IPL system should be 2 weeks apart.
• After that, use the i-Light Pro system
when you start to see hair re-growth in
the treated area.
• Do NOT treat the same body part more
often than every 2 weeks.
After a hair follicle is treated, it can take
one to two weeks for the hair to fall out.
During this time, it may look like hair is
still growing, but really the hair is being
“pushed out.” You may or may not see
these stubs pushed out from the skin.
If you start treating a different body part,
start the process over for that body part.

6
Figure1
i-Light Pro System Diagram Reference

7
Inside the packaging for your i-Light
Pro IPL system you will find a BASE
UNIT with HAND PIECE and POWER
CORD. You will also find a LINT FREE
CLOTH, Instructional DVD and this Use
& Care Guide. The i-Light Pro system
comes equipped with a disposable
REPLACEMENT CARTRIDGE (inside
HAND PIECE underneath NOSE CONE).
Each Disposable Cartridge provides 1,500
flashes before it needs to be replaced.
On the BASE UNIT, there is a SKIN TONE
SENSOR (fig1. J) to test for appropriate
skin tone before usage. You control the
ENERGY LEVEL (fig1. F & I) and choose
the level that’s most comfortable
for you.
The POWER SWITCH (fig1. A) is located
on the side near the top of the unit, next
to the POWER INLET (fig1. B).
A Power Switch
B Power Inlet
C Base Unit
D Hand Piece
E Flash Button
F Energy Level Selection Button
G Cool Down Mode Indicator
H Cartridge Status Indicator Display
I Energy Level Selection Display
J Skin Tone Sensor
K Hand Piece Cord
L Flash Window
M Skin Contact Sensors
N Nose Cone Release Buttons
O Replacement Cartridge
P Nose Cone
Q Power Cord
R Lint Free Cloth
i-Light Pro System Diagram Reference
Getting to Know Your i-Light Pro IPL System

8
1. PREPARE SKIN (see page 23)
• Shave the hair in the treatment area
• Wipe skin clean and dry completely
2. TURN ON & UNLOCK THE
I-LIGHT PRO IPL SYSTEM
(see page 23)
• Turn POWER SWITCH on
• Place skin in the intended treatment
area on SKIN TONE SENSOR for a
few seconds (TOUCHING SKIN TONE
SENSOR)
• UNSUITABLE skin = "BUZZ"
• SUITABLE skin = "BEEP-BEEP" and
the system will unlock
• You must unlock i-Light Pro on each
body part you intend to treat
3. SELECT ENERGY LEVEL
(see page 26-27)
• The i-Light Pro IPL system starts out at
the lowest level
• Test your skin at
lower levels before
increasing
• Higher energy levels improve results
but may be less comfortable
• To increase, press the ENERGY LEVEL
SELECTION BUTTON
• For best results use the highest setting
that is comfortable
QUICK REFERENCE GUIDE (see fig. 1, page 6)

9
4. PLACE HAND PIECE ON AREA TO BE
TREATED (see page 28)
• If SKIN CONTACT SENSORS are NOT
in contact with skin the system will
"buzz" and will not operate if you
press the FLASH BUTTON. Double
check that the contact sensors are in
full contact with the skin.
• If CONTACT SENSORS are in full
contact with skin the system will
"CHIRP" and is ready to flash
• If you're having trouble, try pressing
the hand piece firmly against the skin
5. TREAT YOUR SKIN (see page 28-31)
• After you hear the "CHIRP" press the
FLASH BUTTON to treat skin
• When a flash is delivered, you will:
– See a bright flash of light
– Hear a "POP" sound
(the disposable cartridge)
– Feel a mild sensation of
warmth and tingling
• LIFT the HAND PIECE off the skin and
move it to a new treatment area
• DO NOT flash the same treatment spot
multiple times during one session
• Try to treat in a GRID PATTERN
Note: DO NOT physically mark the
treatment area with grid pattern as this
could cause injury to the skin.
Note: This guide is intended to be a quick
reference for experienced users of the
i-Light Pro. If this is your first time using
the i-Light Pro it is critical that you read
the entire Use and Care Guide for com-
plete directions for important contraindi-
cations, warnings, benefits and risks and
detailed use instructions.
QUICK REFERENCE GUIDE (see fig. 1, page 6)
SKIN CONTACT SENSORS

10
The i-Light Pro IPL system is an over-
the-counter device intended for removal
of unwanted hair.
Skin Tone
It is intended for use only on light to
medium skin colors. To determine if
your Skin Tone is suitable to use with
i-Light Pro place skin in each intended
treatment area next to the Skin Tone
Chart on page 11. If your Skin Tone
matches panels 1-4, you can use the
i-Light Pro IPL system. If your Skin Tone
matches 5-6, DO NOT use the system.
The i-Light Pro system is also equipped
with a built-in SKIN TONE SENSOR that is
designed to help prevent flashing on skin
that is too dark or too tanned for treat-
ment. See page 24-25 for details. Always
test each different area you wish to treat
with the Skin Tone Chart and Skin Tone
Sensor before treating. Some areas are
darker than others.
What Is the Intended Use for the i-Light Pro
IPL System? (Indications)
Hair Color
It is intended for use on naturally black
or brown hair. Do not use i-Light Pro on
white or gray hair because it will not
work. IPL is less effective on lighter colors,
such as blond or red hair.
Body Areas
It is intended for use by women and men
on body hair below the neck, including
legs, underarms, bikini line, chest, stom-
ach, and arms. It has NOT been cleared
in the U.S. for use on the face, head, ears,
back or neck.