Remote King RBT02 User manual

All information contained on this sheet is the property of Remote King PTY LTD. Unauthorised use or reproduction is prohibited.
RBT02 - GARAGE & GATE
REMOTE PROGRAMMING
The following procedure is for programming a RBT02 remote to your gate motor:
All information contained on this sheet is the property of Remote King PTY LTD. Unauthorised use or reproduction is prohibited.
Identify your gate unit.
Locate the ‘OK’, ‘+’ and ‘-’ on
the receiver board, next to
the LCD screen.
Double press the ‘OK’ button
very quickly.
The word ‘Parameter’ will
scroll across the LCD.
Press and release the ‘-’ button
twice.
Undo the screws located on
the left and right side of the
unit.
Remove the cover to reveal
the internal components.
Undo these 3 screws to
remove the receiver board
cover.
1 2
678
3 4
5
RBT02
Continued
28B

All information contained on this sheet is the property of Remote King PTY LTD. Unauthorised use or reproduction is prohibited.
RBT02 - GARAGE & GATE
REMOTE PROGRAMMING
The following procedure is for programming a RBT02 remote to your gate motor:
RBT02
The word ‘Radio’ will scroll
across the LCD screen.
Press the desired button you
wish to program for 1 second.
If programming is successful
the LCD screen will display
‘OK 01’. Wait 10 seconds
before testing the remote.
Double the ‘OK’ button very
quickly.
The words ‘Hidden Button’
will scroll across the LCD
screen.
Simultaeneously press and
hold the top two buttons on
your new remote until the red
LED illuminates and stays on.
PLEASE NOTE:
If you are using the Remote
King branded RBT02B -
Press and hold the 3 & 4
buttons for 3-5 seconds
instead.
9 10
14
11 12
13
28B