Replas JUNIOR SETTING JUNS-1800 FS User manual

ASSEMBLYINSTRUCTIONS
IMPORTANT:Pleasereadcarefullybeforeassembling.
JUNIOR
SETTING
1.8m
FreeStanding
TABLE:
1.PlaceTabletopfacedownonaflatsurface.

2.Placesupportsinsidemetalframe.
NOTE:EnsurethattheTableSupportshavethecountersinkholesfacingoutwardsonthe
supportbase.

3.Usingthe125mmbuglescrewssupplied,fitcrossarmbetweenthetwotablesupports.

4.Usinga3.5mmdrillbit,drillintothesupportthroughthepilotholesinthemetalframe.

5.Usingthe40mmHexScrewssupplied,screwsupportontoframe,takingcarenottoovertightenas
thiscouldstripthethreadinthesupport.

6.Onceallscrewshavebeentightened,turnsettingoverandplaceintoposition.

BENCHES:
1.Benchesarepre‐assembledandreadyforinstallation
TABLE:

1XTableTop‐pre‐assembled
2XTableSupports
1XTableCrossarm
4X14gx125mmBuglescrews
16X12gx40mmHexScrews
COMPONENTSLIST
BENCHES:

2XBenchTops
4XBenchSupports

NOTE:Benchesarepre‐assembled
Ifyourequirefurtherinstallationassistance,pleasecontactyoursupplier.

JUNS-1800 FS
JUNIOR
FREE STANDING
SETTING
620mm 620mm
805mm
340mm
540mm
200mm
540mm
1800mm
340m
1800mm
Crossarm - 1210mm
Side View - TABLE
Side View - BENCH