Rexgear HYDRA-6 Instruction manual

Bitcoin Machine CASE
HYDRA-6

HYDRA-6
[email protected]

Rear panel
HDD/SSD plate
MoBo plate
Front panel
GPU brackets for 13 or 10 cards
Top panel
Overview
1
HYDRA-6
Zip tie points
Safety bar

HYDRA-6
Motherboard / 3.5" HDD
2
Nut Setter-E
Rubber Grommet
Rubber Cushion
Cable Tie Cable Management
PSU
Case stand
Stand off
PSU / VGA Card
40
15
10
1
60
6
15
15

Remove the top panel
Remove four screws on the left and right side of the panel
3
HYDRA-6

HYDRA-6
1. Install the fans
We recommend high speed server fans with greater than 4000 RPM and 150 CFM.
Generic case fans may not provide adequate static pressure for server environment.
2. Install the power supplies
Use rubber cushions to minimize vibration.
Unused power supply holes should be covered to maintain closed system.
4

HYDRA-6
3. Install the motherboard
Stand offs are pre-installed on the motherboard plate.
5

HYDRA-6
4. Install the SSD
You can install one SSD on the side of chassis.
5. Install the SSD/HDD
You can install one SSD/HDD using the mounting plate..
6

HYDRA-6
7
6. Cable management
We recommend that you organize bundles of cables by zip tying them to the zip tie holes on
the bottom GPU bracket.
7. Install the GPU
GPU brackets can be switched from 13 dual slot to 10 triple slot mounting patterns.

HYDRA-6
8
8. Install the safety bar
This helps minimize vibrations or movement of the GPUs.
9. Close the top panel
A closed system is required to maintain positive pressure and front-to-back active airflow
management.This prevents hot exhaust air from circulating back into the equipment intake.