RF Mogul Eagle User manual

1
Before you begin:
Unplug the Eagle Controller to disconnect.
Remove the 2 Phillip screws at the top of the Skew Assembly box that is located behind the reflector. Remove
the Skew cover exposing the GPS. (The GPS can look like any of the 3 GPS photos below)
GPS Replacement Instructions
Skew Assembly Box
GPS
GPS
GPS

2
1) Using a jewelry screwdriver, unscrew
the top three left hand side wire holes.
2 Red, 1 yellow, and 2 black.
2) Move to the wire holder (on old GPS
version) and loosen the screw to turn the
holder counterclockwise.
3) Remove the GPS cap. (Only on old version)
4) Remove the 2 screws attached to the GPS.
5) Remove the old GPS and attached wire
harness.
6) Insert a long screw into the new GPS in the
top hole.
GPS
Wire Holder

3
Please contact RF Mogul Tech Support if you have questions at:
Phone: [phone]
Email: techsuppo[email protected]m
Website: www.rfmogul.com/submit-a-ticket
7) Attach the new enclosed GPS at the top.
You will not place a screw into the bottom
hole (only for old version).
8) Route the wires in the (old version) wire
placement mold and screw the wire holder back
into place.
9) Reattach the wires in the correct placement (2 red wires
together, 1 yellow wire and 2 black wires together) plug your
controller back in and run a test.
New GPS
Wire
Placement
Mold
Red Light Indicator
soft pulse = GPS is
communicating with controller
steady light = there is no
controller communication
Green Board GPS’s will not have a red light.
Blue Light Indicator
solid light = No GPS satellites locked
blinking = 2-3 satellites locked
When blue light goes out it means all satellites locked.