Ride On Cars 7001 User manual

7001 Lamborghini LP640 SV Roadster
Assembly Instructions
1) Take all of the assembly parts.
2) VERY IMPORTANT - T E CAR WILL NOT WORK IF YOU DO NOT COMPLETE T IS
STEP. Take the red wire leading from the battery.

3) Push it on to the fuse terminal as shown.
4) And tuck them down in to the compartment, out of the way.

5) Take the wing mirrors.
6) On the side of the car, remove the wing mirror screw.

7) Click the wing mirror in to place.
8) Then replace the screw to secure the mirror in place, repeat for both sides.

9) The switch on the dash should be made to either remote, or pedal but NOT the centre option,
which will switch the car off (and will not function at all). In pedal mode, the gear lever to the right
changes from forwards to reverse gear.
10) Behind the seat compartment, remove the seat securing screw.

11) Click the seat in to place, and replace the screw to secure it.
12) Remove the two rear spoiler securing screws (circled) on the rear of the car.

13) Take the uprights, they are handed and marked for left and right (looking forwards).
14) Push the top on first, the rest the bottom on the rear of the car.

15) Re-insert and tighten the screw to secure in place. Repeat for both sides.
16) The spoiler top slides in to place on the uprights.

17) Take the steering wheel, and slide it on to the steering column until the holes meet, then secure
it in place with the nut and bolt.
18) The charge socket is next to the seat, covered by a rubber bung.

19) To use the remote, insert 2 x AA batteries, select 'remote' from the dash switch, and drive
remotely just like a normal RC car.
Your car is now ready to use.