ring Smoke & CO Listener Z-Wave User manual

1
Smoke & CO Listener Z-Wave
Technical Manual

2
Ring Smoke & CO Listener
Instructions to locate Z-Wave DSK/QR code
Follow Device inclusion instructions provided in Ring Alarm mobile applications to locate QR code and
enter PIN Code
Factory Reset Instructions
Press and hold the Setup button for 10 seconds. When the LED ring stops blinking, Listener will reset.
This process disconnects the Listener from Ring Alarm. To begin using the Listener again, repeat the
setup process in the Ring app.
“Use this procedure only in the event that the network primary controller is missing or
otherwise inoperable.”

3
To review your warranty coverage, please visit www.ring.com/warranty.
© 2020 Ring LLC or its affiliates.
Ring, Always Home, and all related logos are trademarks of Ring LLC or its affiliates.
Association CC:
This sensor has one Association groups of 1 node. Group 1 is the lifeline group who will receive
unsolicited messages relating to Smoke/CO Siren detected/not detected notifications, case tampering
notifications, and low-battery notifications.
Parameter No. Description Size in
Bytes Value description Default
1
Configures how often the
sensor should send an unso-
licited
Battery Report to the Lifeline.
2
255 to 4200 seconds in 255 second
increments that the sensor should wait be-
tween sending unsolicited battery reports.
4200
2
Configures the sensor to be
able or not able to “hear” CO
Detectors in addition to
Smoke Detectors.
11: Smoke Detector Siren
2: Smoke+CO Detector Siren 1
3Starts the “Installation Test”
Mode 10: Cancel Installation Test Mode 1: Start Installation TestMode 0