Rinnai Infinity 16F User manual

Infinity 16
Internal FE
24 Hour Hot Water
In all areas
0800 746624

New Zealand has a service and
spare parts network in all areas.
Current AS/NZS 3500.4
Current AS/NZS 3000
NZS 5261 Gas Installations Code.
ring the 0800 Rinnai Service

FEATURES AND BENEFITS
IMPORTANT OPERATIONAL SAFETY POINTS
SAFETY POINTS
WARNING ABOUT HOT WATER
OPERATION WITHOUT TEMPERATURE CONTROLLERS
TEMPERATURE CONTROLLERS
STANDARD TEMPERATURE CONTROLLER
OPERATION WITH STANDARD TEMPERATURE CONTROLLERS
Using the Infinity with 1 Standard Temperature Controller
Using the Infinity with 2 to 3 Standard Temperature Controllers
To Turn Off your hot water system
TROUBLESHOOTING
FILTER CARE
WARRANTY
SERVICE CONTACT POINTS
....................................................................................3
...................................................4
.......................................................................................................5
............................................................................7
................................8
..........................................................................9
....................................................10
................11
................................11
........................12
....................................................................13
............................................................................................14
..........................................................................................................15
............................................................................................................19
................................................................................19

temperature shown on the Digital Monitor (or the pre-set limit when Temperature Controllers are
not fitted) the burner will be shut off until the outgoing hot water temperature falls to that shown on
the Digital Monitor (or the pre-set limit).
a. Temperature Controllers are available as an optional extra. These offer Localised Temperature
Control for up to one kitchen and two bathrooms.
b. Temperatures selected at the Controls are retained in the SYSTEM MEMORY.
c. ERROR MESSAGES ARE DISPLAYED on the Temperature Controllers, assisting with
service.

Release latch
Air filter
If the following caution advice is ignored, this may result in death,serious injury or property damage.
DO
Inspect flue regularly to check if a part of the flue
system is dislodged or is being blocked by foreign
material such as tree litter or bird nests.
DO NOT
Obstruct the flue terminal.
DO NOT
Use hair spray or detergent spray near appliance.
DO NOT
Place chemical substances such as chlorine or
ammonia near the appliance.
DO NOT
Use this appliance for any purpose other than the supply
of hot water.
DO NOT
Place flammable materials and chemicals, or spray
aerosols near this appliance.
DO NOT
Block or obstruct any ventilation openings deemed
necessary for the operation of this gas appliance by your
installer.
If abnormal operation, odour or noise are observed,
stop operation and contact Rinnai.
Air filter care:
Clean air filter at least once a month.
Do not operate the appliance without air filter fitted.
Air filter can be detached as follows for cleaning.
IMPORTANT OPERATIONAL SAFETY POINTS
WARNING

"K"Series only
Do not touch the flue outlet whilst in operation.
Do not insert objects into the flue outlet.
Do not cover the filters whilst in operation.
SAFETY POINTS

SAFETY POINTS

WARNING ABOUT HOT WATER
in New Zealand
Rinnai New Zealand

Infinity 16FE

16WF
Use to transfer priority between
temperature controllers.
The controller with priority has
command of hot water delivery
temperature.

to 3
indicator

Other controllers are unable to select priority.

Fault
02 Combustion time out (activated after 60
minutes of continuous use to ensure that
the room does not run out of oxygen)
Blocked air filter
05
(Your unit requires a minimum flow of 2.4 L/min. required to operate.)
Clean air filter as per instructions on page 15.
Reset the appliance by turning the
water heater off at the power point,
leave the unit off for 10 seconds and
then turn the power back on.
Clean air filter as per instructions on
page 15.

Your Infinity 16FE is provided with an air filter, this is located on the front panel of the appliance.
To keep the unit operating correctly, inspect the filter regularly, cleaning at least once a month.
To remove light dust or lint a vacuum cleaner may be used.
Failure to observe these instructions can adversely effect the performance of the water heater, this may
reduce the life expectancy of the appliance.
DO NOT operate the appliance without the air filter fitted.
DO NOT tap or strike the filter to remove contaminates.
DO NOT use hot water.
DO NOT use solvents.
AVOID contact with insecticide sprays.
If the filter is severely clogged, use cold water and a soft brush to remove contaminates.
Removing and cleaning your filter
REMEMBER DO NOT OPERATE THE UNIT WHILE THE FILTER IS REMOVED!
FILTER CARE
Gently pivot the filter to the left until the
locating tabs become free in their slots, pull
towards you to remove the filter from the
appliance.
2.Move the release latch to the left to un-lock
the filter.
1.
Be sure that the filter is completely dry
before attempting to replace.
4.Use a vacuum cleaner or cold water and a
soft brush to remove foreign materials.
3.

Printed in Japan 2003.05
U243-1191
060 00012 39172 5
The benefits conferred by this warranty are in addition all other rights and remedies in respect of the product which
you have under the Trade Practices Act Given installation is in accordance with the manufacturers specification, this
appliance is warranted by Rinnai for the cost of labour and components in the event of defects arising from faulty
materials and/or workmanship with the ensuing warranty conditions.
5
3
8.5