ROA HOBBY Parkour 280 User manual

三源电子（香港）有限公司
ROA HOBBY(HK) LIMITED

三源电子（香港）有限公司
ROA HOBBY(HK) LIMITED
280穿越机调参指导书

Binding ：
1：Please turn the “ELE”
switch to the “REV” position
(as picture 1 shown)
2：Connect the binding cable to the “BAT”
port of receiver (as picture 2 shown)
4：Press and hold the bind key of the transmitter
and turn the transmitter power on(as picture 4
shown). The binding process is finished when
the red indictor on the receiver flashes more
slowly than before.
5.Disconnect the receiver battery and then turn the
transmitter power switch off
Picture 2
Picture 3
Picture 4
3：Connect the aircraft and battery
(as picture 3 shown )
Picture 1

3：将对码条插入:”BAT”的端
口。如图：
Specification Setting ：
1：After blinding process finished, connect the aircraft
battery and turn the transmitter power switch on
(please make sure the signal between the transmitter
and aircraft is connect). Then using USB connect the
computer and aircraft.
Attention：
If the signal between transmitter and computer disconnect,
the TX and RX area shown on the computer is grey,
If the connect the TX and RX will become green and yellow.
(as red circle shown).

参数调整：
Attention：
If the signal between transmitter and computer disconnect, the TX and RX area shown on the
computer is grey.
If connect, when you push the left /right stick .the moving of stick will shown on the computer(as
red circle shown).
。

If mode 2, please select “Yaw left” and then tick "save"
1

Click ”OUTPUT” to enter into motor test.

After tick "TEST OUTPUTS", a dialog
will pop up, please click “Yes”.
Before test the motor, please tick the “Test outputs”

After finished motor test (M1-M2-
M3-M4 ), please save it.

After motor test finished, , please tick the " Test outputs" and then save it.