This instrument is designed for laboratory usage only. Please read this manual carefully before
installing or operating this equipment. The instrument shall not be modified in any way. Any
modification will void the warranty and may result in potential hazard. We are not responsible for
any injury or damage caused by any non-intended purposes and modifying the instrument without
authorization.
1. Check voltage specified on name-plate on the bottom. Make sure if it matches the line voltage
in your location.
2. Install the instrument in a clean, dust-less and ventilated area under 40℃.
3. To enable suction function, connect the inlet of the pump to the outlet of objective equipment
with a high-pressure hose.
4. Never use the pump with any flammable gas or toxic material.
5. When finish pumping, please do not turn off the pump at once and continue to run the vacuum
pump for at least two minutes in order to draw out the mist and tiny liquid to prolong the
service life of the pump.
6. If the pump does not work when turning on the switch, please release the vacuum and turn-on
again. If still fail to start the pump, there may be a problem in the switch or motor, please
contact local distributor for help immediately.
7. In case of any damage with the pump, please directly contact local distributor or us for service.
Do not repair it by yourself to avoid hazard.
When unpacking, notice if the pump is in good situation. If not, please contact the distributor or
contact us by e-mail: export@rocker.com.tw immediately for assistance.
Unpacking
Important notice
