
SiriusXM
OPERATION
Ifcategory set
is
off, press and hold the buttons goes into rapid channel browsing mode, you
can browsing all channels
in
higher speed, ifyou release the touch key, the LCD will show the
information
of
the last browsed channel. , Press the enter key to select the channel showed
on
LCD and play
it.
If
there
is
no key pressed
in
Ss,
the LCD will change back to display current
playing channel information again.
• Category Selection
Ifthe category setting
is
on, long press and hold the buttons over 2S to select previous/next
category.
AS.PS (10)
• Direct Channel Tuning
Short press this button,
"Select:---"
will show
on
the display. Then, the first characterwill flash.
Rotate the Volume knob to select number 0-9 and press it to enter then the second character
flash. Use the same operation to select other character. After select the last number, press
Volume knob to enter and play the desired channel.
• Channel Category Setting
Long press this button to enter category setting while "CAT" will show at the bottom left
of
the
screen, when press again, the category setting will
be
off, and "CAT" will disappear.
BAND/SUB (3)
• Bank
of
presets Selection
In
SiriusXM mode, short press this button to change the bank
of
presets. The current bank
of
presets will change
in
the following order:
SXM1
-SXM2 -SXM3
• Reset
In
SiriusXM mode, press and hold BAND and Enter button to reset the SiriusXM mode to the
factory default setting. When finished the reset operation finished, the locked channel will
be
unlocked, the presets storing will
be
cleared, the parental control passcode will
be
restored
default passcode, etc.
PRESET 1-6
(11
/12/13/14/15/16)
• Store Preset Channel
Long press a PRESET button, the current channel will
be
stored, and the corresponding preset
numberwill appear
in
the display. The PRESET buttons can
be
used to store 6 channels
in
each bank
of
presets (SXM1, SXM2, and SXM3) for convenient access to your favorite
channels.
• Recall Preset Channel
To recall a preset channel, select a bank
of
channels (if needed).Short press a Preset button
and the unit will turn to the corresponding stored channel.
-11 -