Rocky Mountain Saunas Rio Grande User manual

Rocky Mountain Saunas
INSTRUCTION MANUAL
ROCKY MOUNTAIN SAUNAS INC.
7450-M W. 52ND AVE. PMB 123
1-888-358-1270
www.rockymountainsaunas.com
COPYRIGHT 2010 ROCKY MOUNTAIN SAUNAS INC. ALL RIGHTS RESERVED

ROCKY MOUNTAIN SAUNAS INC.
7450-M W. 52ND AVE. PMB 123
1-888-358-1270
www.rockymountainsaunas.com
COPYRIGHT 2010 R SAUNAS INC. ALL RIGHTS RESERVED
4
WARNING:
1) No plumbing or plumbing fixtures should be placed in the sauna.
2) Keep all liquids away from the heating panels
3) Install sauna on a completely level surface.
4) Flammable objects and corrosive chemical substances should be kept far away from the sauna.
Part A: Installation
Unpacking your Sauna
Please identify the 3 boxes(A/B/C) that arrived in your shipment. Place boxes in an open area. All 3 boxes are
labeled with the contents inside. It is recommended that a minimum of 2 people be present for unpacking and
assembly. Lay boxes flat on the ground with lettering facing up. Please make sure the area is clear of debris.
Open the boxes from smallest to largest to make for light, fast work.
The following steps will be divided into 3 sections.
First, we will start with the Colorado/Durango, next will be the Rio Grande and finally the Big Bear Sauna.
The tools required for assembly are a Phillips-Head Screwdriver (optional tools: Rubber mallet & small step
ladder). Note: All panels all labeled with white stickers. Please follow instructions carefully. If you should have
any questions, please do not hesitate to contact us at
1-888-358-1270 or [e-mail]

ROCKY MOUNTAIN SAUNAS INC.
7450-M W. 52ND AVE. PMB 123
1-888-358-1270
www.rockymountainsaunas.com
COPYRIGHT 2010 R SAUNAS INC. ALL RIGHTS RESERVED
9
Rio Grande
Rio Grande
Step 1: Open Box C (Floor panel/Roof panel/Bench panel/Accessories box). Lay the floor
panel at your desired location. The floor heater is towards the front of the sauna.
Moving Your Sauna after Assembly- RMS strongly recommends that you place sliders or ‘EZ Moves’
(Lowe’s or Home Depot) under the furniture feet
or the perimeter corners of the Base Platform of the
Colorado
2person Sauna to allow for easy sliding of the sauna into its permanent location after
assembly.
Place the EZ moves under the corners prior to beginning assembly. (On the Durango, Rio
Grande and Big Bear models, you may want to use a few mores ‘sliders’. Place sliders under the corners and
under the outside
perimeter of the base platform.)
IMPORTANT NOTE: WHEN MOVING THE ASSEMBLED SAUNA:
4. DO NOT PUSH ON THE CABINET ITSELF AS YOU MAY “RACK” OR DAMAGE SAUNA !!
5. ALWAYS PUSH ON THE BASE PLATFORM TO MOVE SAUNA !!
6. SLIDERS MAY BE LEFT IN PLACE FOR EASING MOVING TO FACILITATE DUSTING, VACUUMING, ETC.

ROCKY MOUNTAIN SAUNAS INC.
7450-M W. 52ND AVE. PMB 123
1-888-358-1270
www.rockymountainsaunas.com
COPYRIGHT 2010 R SAUNAS INC. ALL RIGHTS RESERVED
10
Step 2: Open Box A (Front panel/Right Front/Left Front). Install the Front panel first by sliding
the panel onto the metal brackets on the floor panel. Next install the Left Front panel by
raising it above Front panel and guiding it down into the metal brackets. Next install Right
Front panel by same method as Left Front panel. Please remove plastic wrap from Front panel
but be careful so that the glass door does not swing open. At this point, one person should
secure both the panels by holding them.
Step 3: Open Box B (Right Back panel/Left back Panel). Install Right back Panel by sliding panel
onto metal brackets on Floor panel. Semi-tighten Right Back panel to Right Front panel using
Installation bolts (accessories box). Install Left back panel to Right back panel and Left Front
panel (note there are no metal brackets on this side of the floor panel) Semi-tighten using
installation bolts.
Step 4: Install Bench Support panels (located in Box C). Please make all electrical connections
to the Back panel. Install Bench panels (3 pieces located in Box C). Once all panels and seats
are securely in place fully tighten all bolts.

ROCKY MOUNTAIN SAUNAS INC.
7450-M W. 52ND AVE. PMB 123
1-888-358-1270
www.rockymountainsaunas.com
COPYRIGHT 2010 R SAUNAS INC. ALL RIGHTS RESERVED
11
Step 5: Install Roof panel (located in Box C). Guide the roof panel over the sauna and secure
into position. Please feed all the electrical connections that are on the Front/Back/Right/Left
panels thru the holes in the roof panel.
Step 6: Once Roof Panel is securely in place, proceed up top to make all electrical connections.
Please note that there are 3 white ribbon connections (2pin-temp sensor/8pin-power/9pin-
chromo). Match the male/female black electrical cord heater connections.
Step 7: Install Top Cover. Feed the main power cord through the hole in the dust cover.
Optional to secure dust cover with screws provided.

ROCKY MOUNTAIN SAUNAS INC.
7450-M W. 52ND AVE. PMB 123
1-888-358-1270
www.rockymountainsaunas.com
COPYRIGHT 2010 R SAUNAS INC. ALL RIGHTS RESERVED
12
Step 8: Install Cup Holder(s), Magazine Rack, Towel Holder. These items may be installed in
any location that you desire. Mount Air Purifier to Back panel by using a wood screw (just like
hanging a picture).
Step 9: Install Door Handle. If you have purchased the LCD Upgrade then you may connect it
to the 12volt Cig-adapter located on the ceiling, if not then cover the adapter with the wood
knob provided in your packaging.
Step 10: Once Installation is complete plug in sauna. Please make sure to read the “How to
Use Instructions” at the end of this booklet.
Big Bear