9
Phone number and ID programming
Phone numbers are programmed in the phone book on the SIM card. Before starting
phone number programming, track if there are one of the following numbers in the book:
DSP1, DSP2, DSP3, DSP4, MOB1, MOB2, MOB3, MOB4, PNR, SNR, MNR. In case one
of these numbers exists, it will be deleted as it will be reprogrammed later.
Monitoring station numbers have the DSP indicative next to the name followed by a figure
from 1 to 4, thus making the difference between the 4 phone numbers associated to one or
several monitoring stations. As an example, the third monitoring station number is thus set:
Name DSP3, phone number 0723471891.
For option “name”, set DSP3. For option “phone number”, set the mobile phone number
where information must be transmitted to.
For the owner’s phones, use MOB indicative followed by a figure from 1 to 4. As for the
monitoring station phone numbers, the figure makes the difference among the 4 phone
numbers which can be associated to the owner. Example: if the second mobile phone
number of the beneficiary is to be programmed, enter name MOB2 followed by the number
of the respective phone at the name section in the phone book: Name MOB2, phone
number 0721567829.
If the control panel is partitioned, then the monitoring station phone numbers 1 and 3 as
well as those of the alarm system owner are reserved for the first partition while 2 and 4
are reserved for the second one. Events occurred in the first partition are transmitted only
to numbers 1 and 3 while events occurred in the second one are transmitted to numbers 2
and 4. Events occurred at the communicator are transmitted to all numbers.
IDs are also set in the phone book:
For the first partition, the name begins with PNR and continues with the account number.
Example:
PNR3421, where 3421 is the account number of the corresponding partition being set in
the burglary control panel. For the phone number corresponding to that name, add 6 zeros.
Name: PNR3421
Number: 000000
For the second partition, the name begins with SNR and continues with the account
number. Example: SNR9832, where 9832 is the account number of the second partition,
being set in the burglary control panel. For the phone number corresponding to that name,
add 6 zeros.
Name: SNR9832
Number: 000000
For the communicator, the ID is set using the MNR indicative followed by the account
number. Example: MNR5674, where 5674 is the communicator account number.
Name: MNR5674
Number: 000000
Events with this ID will be transmitted to all phone numbers in the phone book.
If messaged are not to be transmitted to certain phone numbers, then those numbers will
be deleted in phone book.
