Roger EA-1 User manual
Roger Access Control System
EA-1 v1.0
External Antenna Module
Rev. A
EA-1 Instruction Manual Rev.A.doc 20/10/2010
Page 2from 4
General information
EA-1 module is dedicated to operate as external loop antenna, which can be connected to master
proximity reader by means of included 1,5 meter length cable. EA-1 module is designed for
installation inside the enclosure of Helios type entryphone phones made by company 2N. Device is
equipped with speaker, which replicates acoustic signals from connected reader and with anti-
sabotage (tamper) contact, which can be connected to external circuit of anti-burglary or anti-
sabotage signalling. The module is protected against moisture and can be used outdoors if it is
installed inside additional enclosure that provides protection against rainfall. EA-1 module can be
connected to SDC66 lock (Roger) or other Roger card operated locks/access readers if they are
equipped with adequate connector.
Installation inside HELIOS entryphone
The module must be installed inside the enclosure of the entryphone phone by means of fixing pins
located at the bottom of the enclosure and then connected with included cable to SDC66 lock. The
module must be pushed into fixing pins and no additional screws are required. Connection of EA-1
module with SDC66 lock is shown in figure below.
Note: Modification (e.g. shortening) of included cable is forbidden. Possible cable excess can be wind
up and placed in convenient place.
The purpose of anti-sabotage (tamper) contact is to signal attempts of the enclosure opening. In
normal condition i.e. when the module is installed inside entryphone phone and its enclosure is
closed, there is shorting between TMP1/TMP2 tamper contacts. Enclosure opening results in
interruption of connection between mentioned above contacts. Anti-sabotage (tamper) contact can
be connected to anti-sabotage loop of alarm system or used to trigger dedicated alarming device.
EA-1 Instruction Manual Rev.A.doc 20/10/2010
Page 3from 4
EA-1 Instruction Manual Rev.A.doc 20/10/2010
Page 4from 4
Technical specification
Parameter Characteristics Remarks
Reading distance Up to 10 cm for ISO
proximity cards
(dimensions of typical ATM
card) or approx. 5 cm for
proximity tags (key fob)
Reading distance is specified for
model proximity cards in optimal
position against the module, when
card geometrical axis coincides with
loop antenna geometrical axis.
Reading distance can vary
depending on the card type and the
card producer.
Dimensions 85 x 58mm
Connection cable length 1,5m No cable modifications allowed
Environmental conditions Temp.: -25°C- +60°C,
Relative humidity: 10 to
95% (no condensation)
The module requires protection
against rainfalls and can be used
outdoors only if it is protected
against rainfalls.
Certificates CE
This symbol placed on a product or packaging indicates that the product should
not be disposed of with other wastes as this may have a negative impact on the
environment and health. The user is obliged to deliver used equipment to the
designated point of collection of used electric and electronic equipment. For
detailed information on recycling, contact your local authorities, waste disposal
company or point of purchase. Separate collection and recycling of this type of
wastes contributes to the protection of the natural resources and is safe to health
and the environment. Equipment weight is specified in instruction.
Contact information
Roger sp. j.
82-410 Sztum
Gościszewo 59
Tel.: +48 55 272 01 32
Fax: +48 55 272 01 33
PSTN technical support: +48 55 267 01 26
e-mail: biuro@roger.pl
Table of contents
